11Part Names and Functions (continued)Rear Panel1. DC 24V OUT terminalDC 24 V is output while this unit is operating with the AC powersupply.This will supply DC power supply to the camera adapter (AG-CA300).24 V is not output when this unit is operating with the DC powersupply.2. CA IN terminalConnect the BNC cable from the camera adapter.Connect with the BS OUT connector of the camera adapter(AG-CA300) using the BNC cable (5C-FW).3. CA OUT terminalConnect the BNC cable from the camera adapter.Connect with the BS IN connector of the camera adapter (AG-CA300) using the BNC cable (5C-FW).4. GENLOCK IN terminalThis is a reference signal input terminal to lock this unit with anexternal sync.5. GENLOCK OUT terminalThis is a loop through with the GENLOCK IN connector.6. VIDEO OUT terminalComposite signal is output.Color phase will be also locked to the reference signal whenthe BS signal (burst sync) is input as a reference signal into theGENLOCK IN connector.The composite signal is not output from the VIDEO OUTterminal when the video format for the camcorder is set to1080-23.98PsF.7. RET IN VIDEO signal input terminalThis is an input terminal for the return video signal from this unitto the camera adapter (AG-CA300).This will input a composite signal.Video cannot be viewed on the CRT VF when the video formatfor the camcorder is set to 1080-23.98PsF.8. RET IN SDI signal input terminalThis is an input terminal for the return video signal from this unitto the camera adapter (AG-CA300).This will input a SDI signal.Video cannot be viewed on the CRT VF when the video formatfor the camcorder is set to 1080-23.98PsF.9. SDI 1 output terminalThis will output the SDI signal that was output from thecamcorder.10. SDI 2 output terminalThis will output the SDI signal that was output from thecamcorder.Same signal as the signal output from SDI 1 output terminal isoutput.11. INCOM/TALLY terminalThis is a connector between this unit and the external intercomsystem and TALLY system.12. TALLY selection switchThis is a switch to match with the TALLY system connected tothe INCOM/TALLY terminal.Select either contact or supplied voltage. For supplied voltage:compatible with 12 V or less.Connect to the power outlet using the attached power supplycable.MAKE: Select this when the TALLY input signal is a contactV: Select this when the TALLY input signal is a suppliedvoltage13. INCOM selection switchThis is a switch to match with the INCOM system connected tothe INCOM/TALLY terminal.Select either 4-wire format or RTS format.4W: Select this when it is a 4-wire formatRTS: Select this when it is a RTS format14. RET signal selection switchThis is a switch to select the return signal from this unit to thecamera adapter (AG-CA300).Select the RET signal supplied to either the RET IN VIDEOsignal input terminal or the RET IN SDI signal input terminal.VIDEO: Selects the VIDEO signal supplied to the RET INVIDEO signal input terminal.SDI: Selects the SDI signal supplied to the RET IN SDIsignal input terminal.15. REMOTE terminalConnect the AG-EC4 (optional) or the AJ-RC10 (optional), andcontrols the camcorder.DC 24V OUTCAOUTINGEN LOCK RET INVIDEOOUTOUTINSDI OUT INCOM/TALLYREMOTE DC 12V IN AC INTALLYMAKEINCOM4WRETSDIVIDEOV RTS21VIDEO SDI1 2 3 4 5 6 7 8 9 10 11 121314 15 16 1817