- 52 -Perform focus adjustments using the focus ring. If auto focusing is difficult due to the conditions,then use Manual Focus.≥ Switch to Manual Mode. (l 44)1 Set the FOCUS A/M/¶ switch to [M] to enable Manual Focus.≥ It will switch to MF from AF.2 Adjust the focus by rotating the focus ring.≥ The focus value can be set from MF00 (Focus distance*: approximately 10.0 cm [When [FOCUSMACRO] (l 89, 156) is set to [ON]]) to MF99 (Focus distance*: infinity). The larger the focusvalue gets, the further the position where focus is achieved.* Focus distance refers to the minimum distance where a subject can be brought into focus.≥ If you move the FOCUS A/M/¶ switch towards [¶], focus will be adjusted to MF95 on the infinityside. (The FOCUS A/M/¶ switch will return to the [M] position.)≥ To return to Auto Focus, set the FOCUS A/M/¶ switch to [A], or set [AF] to [ON] and switch toAuto Mode. (l 44)≥ If you set [FOCUS MACRO] to [ON], when the distance to the subject approaches within 0.95 mapprox., the unit switches to the macro range and or . (The unit may switch to the macrorange even when the distance to the subject is 0.95 m or more depending on the subject.)≥ Depending on the zoom magnification, this unit may fail to switch to the macro range, or go to anon-displayed focus value.≥ When you perform a zoom operation in the macro range, this unit may go out of focus.≥ When [AF] is set to [ON] and this unit is set to Auto Mode, auto focusing is performed regardlessof the position of FOCUS A/M/¶ switch. (l 44)≥ The unit of the focus value display varies depending on the [FOCUS DISPLAY] setting in the[DISP SETUP] menu. You can also change the setting so that the on-screen display does notappear. (l 171)RecordingFocusA FOCUS A/M/¶ switchB PUSH AUTO buttonC Focus ringPUSH AUTOFOCUSAM
