Panasonic AJ-D400P Service Manual

Also see for AJ-D400P: Operating instructions Operating instructions Operating instructions

Contents

Panasonic AJ-D400P Service Manual Manual pdf 79 page image

1-31. LISTA Connection and Boot UpTEST POINT TP601:ATF ERR (SERVO Board)TP113:R/P HSW (SERVO Board)TG300:GND (SERVO Board)M.EQ P/C (AD Board should be installed), OscilloscopeTAPE VFM3581KM, VFM3681KMTOOL VFK1481 (LISTA Software), VFK1186 (LISTA Cable)1. Connect the LISTA Cable to A/D board on PC.2. Connect the Clips of LISTA Cable to test point on Servo Board as follow as below.".ATF: TP601#.HSW: TP113$.GND: TG3003. Boot up the LISTA software on DOS mode.% Install and Boot up.All files on the floppy disk (VFK1481) copy to created directly on PC (i.e. C:¥LISTA).Type “LISTA” and press ENTER Key, then boot up the LISTA software.4. Select the item “DVC PRO” then “AJ-D700” for selected model on the menu. (AJ-D400P/E/D700P/E isequivalent to AJ-D700).5. After selected model, appeared alignment tape data on the screen for select the Serial number on thealignment tape. But if LISTA software have not resisted data of alignment tape, press the ESC key, thenmain menu is display on the screen. And select item “<4> Alignment Tape” for entry the data on theattachment sheet, which is enclosed of alignment tape.