– 82 –Setup Card OperationsSetup Card Data OperationsOperations to store setting data on setup cards and read out stored data are performed at theSET UP CARD page of the setting menu.|Note{When operating the unit with a remote controller, the SET UP CARD page cannot be operatedfrom the unit.Formatting setup cards1 Set the MENU SET/OFF switch to SET. The page on which the previous setting menu oper-ations were completed appears on the viewfinder screen. (When the menu is used for thefirst time, the first page appears.)2 Press the MENU switch repeatedly until the SET UP CARD 1/2 page shown below appears.(This operation can also be performed using the PAGEoUP/DOWN function.)3 Press the SHIFT/ITEM button repeatedly to move the cursor to the CARD CONFIG. po-sition.4 A menu shown below appears when the UP (or DOWN) button is pressed.5 Press the UP button to format the set up card. When the setup card has been formatted,the message shown below appears.|Note{When setup cards are formatted, the setting conditions at that time are also input simulta-neously.6 When menu operations have been completed, return the MENU SET/OFF switch to OFF.The setting menu disappears from the viewfinder screen and the displays indicating theunit’s current status appear at the top and bottom of the viewfinder screen.- SET UP CARDC CARD¢ READREADUSERSE L ECTW R I TE0SE L ECT 01 / 2O NF GI-AD AT- SET UP CARDCCCARD¢READREADUSERSE L ECTWWR I TE0SE L ECT 01 / 2O NF GGIN F I (? Y : UP N, : DOO )N-AD AT- SET UP CARDC CARD¢READREADUSERSE L ECTW R I TE0SE L ECT 01 / 2O NF GI-AD ATF O R M AT O K
