7Chapter 7 Menu description tables837-3-8 SKIN TONE DTLItem/Data storageVariablerange Remarks$ SKIN TONE DTL ONOFFFor selecting ON or OFF for the skin toneDTL.$ SKIN TONEZEBRAONOFFFor selecting ON or OFF for ZEBRA in theSKIN TONE range.SKIN DTL CORING 0:5:7For setting the SKIN TONE DTL coring effect.ZEBRA signals are superimposed only whenmenu operations have been performed toopen the page and ONhas been selected as the SKIN TONE ZEBRAitem setting. Exercise care during operationsince these signals will be superimposed ontonot only the viewfinder but the main linesystem as well.Y MAX 000:190:255For setting the maximum luminance signalvalue for applying the SKIN TONE effect.Y MIN 000:010:255For setting the minimum luminance signalvalue for applying the SKIN TONE effect.I CENTER 000:035:255For setting the center position on the I axis(setting the area to which the SKIN TONEeffect is to be applied).I WIDTH 000:055:255For setting the width of the area to which theSKIN TONE effect is to be applied on the Iaxis centered on the I CENTER.Q WIDTH 000:010:255For setting the width of the area to which theSKIN TONE effect is to be applied on the Qaxis centered on the I CENTER.Q PHASE –31:+00:+31For setting the phase of the area to which theSKIN TONE effect is to be applied asreferenced to the Q axis.R-YB-YQ-WIDTHI-WIDTHQ-PHASEI-CENTERYY-MAXY-MIN0=SKIN TONE AREA– direction+ directionThe underlining in the variable range column indicates the setting in the preset mode.S C U F ES C U F ES C U F ES C U F ES C U F ES C U F ES C U F ES C U F ES C U F E7-3-9 KNEE/LEVELItem/Data storageVariablerange RemarksMASTER PED –200:+018:+200For performing the MASTER PEDESTALsetting.$ MANUAL KNEE ONOFFFor setting the mode which is to be establishedwhen the AUTO KNEE switch is at OFF. TheKNEE POINT/SLOPE setting value is activewhen ON is selected.KNEE POINT 70.0%:93.0%:107.0%For setting the KNEE POINT position in 0.5%steps.KNEE SLOPE 00:85:99 (98)For performing the KNEE width setting.Same as KNEE OFF when set to 0.The range of values that can be selectedusing the AJ-EC3E is 00 to 98.WHITE CLIP LVL 90%:109%For performing the WHITE CLIP LEVELsetting.A.KNEE POINT 80%:93%:107%For setting the AUTO KNEE POINT positionin 0.5% steps. This item is active when theOUTPUT/AUTO KNEE selector switch is setto CAM.AUTO KNEE ON.A.KNEE LVL 100:107:109For performing the AUTO KNEE level setting.A.KNEERESPONSE1:4For setting the AUTO KNEE response speed.$ WHITE CLIP ONOFFFor selecting ON or OFF for the WHITE CLIPfunction. The WHITE CLIP LVL setting valueis active when ON is selected.S C U F ES C U F ES C U F ES C U F ES C U F ES C U F ES C U F ES C U F ES C U F EItems with $ in front of their names are set by the PAINTMENU SW ($) R/W menu items on the R/WSELECT> screen.Items without $ in front of their names are set by the PAINTMENU LEVEL R/W menu item.For details, refer to “7-6-2 CARD R/W SELECT.”
