Panasonic AW-CB400L Operating Instructions Manual

Also see for AW-CB400L: Service manual

Contents

13 (E)Operating procedureSub carrier phase adjustment1 Select the first camera to be adjusted by pressing the CAM CONTROL button.2 Press the MENU button to display the menu on the LCD panel.3 Turn the CONT dial to display the G/L SETTING menu.4 Push the CONT dial straight down twice to display SC COARSE on the bottom line of the LCD. The sub carrier phase cannow be adjusted coarsely by turning the CONT dial.When the CONT dial is pushed three times, SC FINE appears, and the sub carrier phase can now be adjusted finely byturning the CONT dial.5 Keep adjusting the SC COARSE and SC FINE phase so that the sub carrier (colour) phase of the video signal output isaligned with the colours of the programme output (split colour bar output) of the video switcher or other unit that serves asthe reference.The colour phase can be adjusted more accurately if a vectorscope is used.6 Select the next camera by pressing the CAM CONTROL button, and adjust the sub carrier phase of the next camera.Repeat this for all the connected cameras.$ Video adjustment of camerasThis adjustment is performed when the pedestal of a multiple number of cameras is to be brought into alignment.1 Select the first camera to be adjusted by pressing the CAM CONTROL button.2 Set the lens iris to manual, and stop it down.3 Use an oscilloscope or waveform monitor to adjust the pedestal level to correspond to the reference level using the totalpedestal dial.4 Select the next camera by pressing the CAM CONTROL button, and adjust the pedestal of the next camera. Repeat thisfor all the connected cameras.WhiteYellowCyanGreenMagentaRedBlueBlackColour bars of cameraSplit lineColour bars of specialeffects unitAdjust the pedestal levelto the reference level.