Panasonic AW-HE40 Quick Start Manual

Also see for aw-he40 series: Installation & setup guide Operating instruction Quick start guide Manual Quick start guide

(Setting Procedure via AW-RP50)① Press the button 1 at . - (Fig. 1-A)② Hold down the CAMERA OSD button - (Fig. 1-B) at the upper right of the panel. The button will light up andthe on-screen menu will be displayed on SDI (or HDMI) output image from the selected AW-HE40 camera.* If CAMERA OSD button is held down again while it is lit, the on-screen menu will disappear and the button’slight will go off.③ Use F1 dial to change the following camera menu setting. - (Fig. 1-C)【Location】・ Camera ＞ Scene ⇒ Put the setting to [Manual1]. * The setting can be selected from [Manual1 – 3].④ Press “IRIS AUTO” button (*1) on the front panel to switch between Auto and Manual. - (Fig. 1-D)(*1) When this button’s light is ON, it indicates Auto Iris. When it is OFF, it indicates Manual Iris and the iriscan be adjusted using IRIS dial. - (Fig. 1-E)The status of “IRIS AUTO” button is linked with the following camera menu setting.・ Camera ＞ Scene ＞ Contrast ＞ Contrast Mode ⇒ [Auto], [Manual](Displayed On-Screen Menu)Controlling Iris of AW-HE40 Camera ManuallyTurn F1 → Select “Camera” → Press F1 Press F1 → “Full Auto” blinks（A）（D）（B）（C）(Figure 1)Turn F1 → Select “Manual1” → Press F1（E）

/ 2

Related manuals for Panasonic aw-he40 series