- 24 -Connections5 1394 connectorThis is for controlling the convertiblecamera, in which an IEEE 1394 cardhas been installed, and the pan/tilt head.As the connecting cable, use an IEEE1394 cable.OThis unit cannot be controlled directlyusing an IEEE1394 card. A convertiblecamera containing the plugged-inIEEE1394 card is needed.6 CONTROL IN IP/RP connectorThis is for camera/pan/tilt head controlsignals.Connect this to the PAN/TILTCONTROL OUT connector on thecontrollers AW-RP301/AW-RP305/AW-RP501/AW-RP505, or multiport hubAW-HB505, CONTROL OUT TOPAN/TILT HEAD connector on thecontroller AW-RP605A, or CONTROLOUT TO PAN/TILT connector on thecontroller AW-RP400.Use a 10BASE-T straight cable (UTPcategory 5) for the connecting cable.ODepending on the controller to be used,it may be necessary to change theswitch positions. For details on how todo this, refer to the section on “Controllerselection switch settings” under“Installation” (page 10).OFor your safety, connect to an Ethernetnetwork which does not exceed thevoltage limit of the Ethernet connector.7 Y OUT connectorThis is for camera video signal output.Connect this to the Y IN connector onthe controller or to a monitor, etc.Use a coaxial cable (BELDEN 8281) forthe connecting cable.8 Pr/SDI OUT connectorThis is for camera video signal output.Connect this to the Pr IN connector onthe controller or to a monitor, etc.SDI signals can be output when an SDIcard (AW-PB504N, etc.) is installed inthe convertible camera for use.Use a coaxial cable (BELDEN 8281) forthe connecting cable.OTo switch from Pr to SDI or vice versa, itis necessary to change the switchpositions. For details on how to do this,refer to the section on “Transmissionsignal selection setting” under“Installation” (page 11).$ Connecting the base connector rear panel and the baseconnector front panelPin No. Signal1 DC 12V2 GND3 TPB 24 TPB5 TPA 26 TPA