Panasonic AW-SW350E Operating Instructions Manual

Also see for AW-SW350E: Service manual

Contents

Panasonic AW-SW350E Operating Instructions Manual Manual pdf 6 page image

Q Power Indicator [POWER]Lights (green) when power is supplied to DC Power Input Terminal L and Power SwitchW set to the ON position, and goes out when Power Switch W is set to the OFF position.W Power Switch [POWER ON/OFF]Power is switched on and Power Indicator Q lights when this switch is set to the ONposition, provided that power is supplied to DC Power Input Terminal L. Power isswitched off and Power Indicator Q goes out when the switch is set to the OFF position.9 (E)ENGLISH8 (E)MAJOR OPERATING CONTROLS AND THEIR FUNCTIONSTOP (CONTROL PANEL)E Wipe Pattern Selection Switches [WIPE PATTERN]To select a wipe pattern after pressing Wipe Switch y. One of the nine patterns can beselected. The selected switch lights.R Setting Switch [SETTING]This functions as the shift key for the wipe patterns. While it is held down, the Wipe PatternSelection Switches can select the functions described below. The functions are indicatedwith blue characters.SF0, SF1, SF2: These are used to set the three wipe softness levels.The minimum softness level is set by SF0 (a hard key), and the maximumsoftness level is set by SF2.MWR: This makes it possible for the user to set the initial statuses of the panelwhen the power is turned on.First, set the statuses of the panel to be recorded. Once the setting hasbeen performed, keep pressing MWR while holding down the SETTINGswitch until the nine switches go off. The recorded statuses will bereproduced when the power is next turned on.INT: This is used to restore the initial settings which were established at thefactory.Keep pressing INT while holding down the SETTING switch until the nineswitches go off. The same statuses as the factory setting statuses will beestablished when the power is next turned on.FRZ: This is used to set the freezing of the Video Input 5 signal to ON or OFF.When FRZ is pressed while holding down the SETTING switch, the VideoInput 5 signal is frozen. While the signal is frozen, the FRZ w LED lights.This signal can be used as the source of the VIDEO IN 5 signal.✽If the freeze function is used while the FS switch is in the OFF position,only the Video Input 5 signal will be set to the FS ON status.POWERINCOMLEVELGEN-LOCK PHASEWIPE PATTERN TRANSITION TIMEKEYSETTING COLORWH1S F 0WH2S F 1WH3 AUTO TAKE KEY AUTO AGAINSOURCEIN5FMEMKEY AUTOCLIPS F 2YLWMWRCYNI N TGRNF R ZMGT RED BLENN / RRI N VH SC SC FINEONOFFA1 2 3 4 5FMEMBLACKMIXFRZWIPEAUTO TAKEBARCOLORBBLive Switcher AW-SW350Even when the Power Switch is at the OFF position, some of the power supply circuitsare still operating. To turn off the power completely, set the external power adaptor toOFF.CautionSF0MWRSF1INTSF2FRZINV