Panasonic BB-HCM311 Specifications

Also see for BB-HCM311: Operating instructions Operating instructions Troubleshooting Getting started Installation

Contents

external output control

Panasonic BB-HCM311 Specifications Manual pdf 2 page image

Design and specifications are subject to change without notice. 10M1204SK-HCM311.LT.X Printed in JapanModel No.Product typeImage data compression systemResolutionImage qualityFrame rate* 1 (image refreshing speed)SecurityIPsec function* 3Encryption algorithmCommunication protocolNo. of simultaneous accessesNo. of temporarily stored images* 4Angle of viewPan (horizontal direction)Tilt (vertical direction)Rotating speedNo. of pixelsLens focal pointLens brightnessRequired light intensityVoice directionVoice data compression systemVoice bandAudio inputAudio output* 5NetworkI/O connector for sensorSD Memory Card slotOperating temperatureOperating humidityExternal dimensions (WxHxD)WeightPower sourcePower consumptionBB-HCM311Indoor network camera with built-in Web server function and voice functionJPEG (Motion JPEG for moving image display)640 x 480, 320 x 240, 160 x 1203 modes (Favor Clarity, Standard, Favor Motion)Max. 30 frames/sec (320 x 240, 160 x 120), Max. 12 frames/sec (640 x 480)* 2ID, password, IPsecESP encryption, EPS authentication, transport mode/tunnel mode IKE (Internet Key Exchange)DES-CBC, 3DES-CBC, AES-CBCIPv4/IPv6 dual stackIPv4: TCP, UDP, IP, HTTP, FTP, SMTP, DHCP, DNS, ARP, ICMP, POP3, NTP, IPsec, UPnPIPv6: TCP, UDP, IP, HTTP, FTP, SMTP, DNS, ICMPv6, POP3, NDP, NTP, IPsecMax. 30 accesses (max. 10 accesses with voice reception)(No. of registered users: max. 50, with individual IDs and passwords)Approx. 125 images: 320 x 240 resolution, standard image quality(approx. 16 KB per image) (without using SD Memory Card)53° in right-and-left direction (total of 173°-angle display possible using pan operation)40° in up-and-down direction (total of 105°-angle display possible using tilt operation)–60° to +60° (remote operation)+20° to –45° (remote operation)Pan: Max. 80°/sec, Tilt: Max. 80°/sec1/4 inch, approx. 320,000 pixels, CCD sensorFixed (focal range: 0.5 m (20 inches) to ∞)F3.53 to 100,000 lx (in Color Night View mode: 0.2 to 100,000 lx)Half-duplex two-way communication (transceiver system)ADPCM 32 kbps300 Hz ~ 3.4 kHzBuilt-in microphone or external microphone (sold separately), external microphone inputterminal (3.5-mm dia. mini-jack)Audio line output terminal for external speaker(3.5-mm dia. stereo mini-jack, monaural output)Ethernet (10Base-T/100Base-TX)G GND1 External Senser InputG GND2 External Senser Input3 External Device Control Output4 DC Power Output Terminal (10.5–13.5 VDC)Full size (operation guaranteed for 1GB, 512MB, 256MB, 128MB and 64MB SD MemoryCards manufactured by Panasonic)0° to 40°C (keep the product out of direct sunlight)20% to 80% (with no dew condensation)Approx. 100 x 100 x 73 mm (main unit, excluding protrusions)300 gSpecial AC adaptor (included with product; from 120 VAC (60 Hz) to 12 VDC;Power cord length: approx. 4.8 m)Standby mode: approx. 3 W, max. (during pan scan): approx. 6 WSpecifications of BB-HCM311 Network CameraOSCPUProtocolInterfaceWeb browserAudioMicrosoft ®, Windows ®XP, Windows ®2000,Windows ®Me, Windows ®98SE• For monitoring of image from one camera unit: Pentium RIII (800 MHz or greater)• For monitoring of images from multiple camera units: Pentium R4 (1.8 GHz or greater)TCP/IP (HTTP, TCP, UDP, IP, DNS, ARP,ICMP) protocol must be installed.10/100-Mbps LAN card must be installed.Internet Explorer 6.0 or laterAudio input/output function (microphone, speaker, etc.)Specifications for Compatible PCMicrosoft ®, Windows ®XP, Service Pack 1or laterTCP/IP (HTTP, TCP, UDP, IP, DNS, ICMPv6,NDP) protocol must be installed.For IPv4 For IPv6* 1 This varies depending on the subject, image quality, network environment, PC performance, etc.* 2 The image update speed may decrease when favor-motion mode is set, when images are recorded onto an SD Memory Card, and when IPsec isused, as well as due to the network environment and PC performance.* 3 Transport mode (mode for IPsec communication between terminals, for IPv4 only) operating environment: Microsoft ®Windows ®XP Service Pack 1or later only, tunnel mode (mode for IPsec between VPN routers, IPv4/IPv6)* 4 The number of images that can be stored varies depending on the subject. * 5 Install an amp or use a speaker with a built-in amp.Server sectionCamera sectionAudio sectionConnectorsGeneralIPsec*4 SupportedA Wide Range of Camera Control FunctionsThe BB-HCM311’s high-speed pan and tilt functionsoffer a maximum rotation speed of 80°/sec. Thesefunctions can be operated from a PC or cell phone toquickly change the camera direction. Using the built-inalarm function and a commercially available externalsensor, the camera can also be automatically pointedto a specified direction when the sensor is activated.The camera is equipped with the following controlfunctions for easy, effective monitoring in the desireddirection.The Alarm-Controlled Image Transfer function uses acommercially available external Sensor or switch andsends the image only when there is an action such asturning on the light or opening the door. The Timer-Controlled Image Transfer function automaticallytransmits images according to the set time zone andthe day of the week. These convenient functionseliminate your need to constantly check the image.IPsec is a technology used to encrypt data packets inorder to prevent eavesdropping by third parties. Whencombined with a conventional authentication functionbased on user names and passwords, IPsec offersenhanced security.• Click & CenterWhen the mouse button is clicked at a location on theimage, the camera moves so that the image is shownwith the selected location at the center.• External Output ControlThis provides ON/OFF operation of an externallyconnected device. For example, it can be used to turnon a light when the surrounding area becomes dark orto turn on a buzzer in case of an emergency.• Pan and Tilt Movement• PresetThis function lets you preset the camera direction.You can use it to view the image captured from thepreset camera position with one-touch operation.Use of the built-in microphone and a separatelypurchased amp-equipped speaker enables two-wayvoice communication (transceiver system)*2 betweenthe network camera and a PC used to monitor thecamera image. Voice transmission and reception canbe switched easily from the PC used to monitor theimage. For example, it allows people in a head office toprovide instructions or messages to people on a salesfloor while observing the image on their PC.Two-Way Voice Communications SupportedNetwork CameraBB-HCM311Pan(173° maximum)Tilt(105° maximum)Our new network cameras allow the use of a virtuallyunlimited number of IP addresses*3 by supportingIPv6, a next-generation protocol. The IPv4/IPv6 dual-stack feature enables you to use IPv4 at the presentand switch over to IPv6 in the future.* 1 This logo mark is issued by the IPv6 Ready Logo Program Committee, an IPv6 promotion group established mainly by the IPv6 Forum.* 2 This function can be used with a PC only. It cannot be used with a cell phone. To hear the voice transmitted from the PC, a commercially availablespeaker with a built-in amp must be installed. The transceiver system does not allow simultaneous transmission and reception of voices.The BB-HCM311 may require a version upgrade to operate in the IPv6 environment.For the latest information, visit Panasonic's support Web site (http://panasonic.co.jp/pcc/products/en/netwkcam/).*3 An IP address is a unique number assigned to each user so that the user can be identified on the Internet.* 4 IPsec is an IP security protocol for data encryption standardized by IETF, an international community devoted to the standardization of Internetspecifications.IPv6-Ready*When e-mail function is used to transfer images or messages, e-mailtransmission may not be possible in some cases due to the mail serverauthentication system (SMTP authentication, etc.) used by yourInternet service provider.*The image transfer functions can be used only with a PC. With a cellphone, only the e-mail transmission function can be used.Alarm-Controlled and Timer-ControlledImage Transfer FunctionsStand mountingsectionLens Lens coverMicrophone IndicatorSD MemoryCard slotAC adaptorconnectorExternal microphoneinput terminalAudio output terminalEthernet connector(10/100Base-T(X))I/O connector

/ 2

Related manuals for Panasonic BB-HCM311