ENGLISHREAR/SIDE VIEWCOLOR OFF button/lampPress the COLOR OFF button. The button lights and thescreen becomes monochrome. When the COLOR OFFbutton is pressed while lit, the light goes off and thenormal screen is restored.Use this function to confirm the noise in the brightnesssignal or to confirm the white balance.NOTE: This function is invalid with the RGB-input screen.SCREENS CHECK button/lampPress the SCREENS CHECK button. The button lightsand the screen changes in the following order:Normal screen[Red screen[Green screenBlue screenpPress the SCREENS CHECK button when the bluescreen is displayed. The light goes off and the normalscreen is restored.Use this function to confirm or adjust CHROMA orPHASE.NOTE: This function is invalid with the RGB-input screen.ASPECT button/lampWhen the ASPECT button is pressed while the screenratio is 4:3, the button lights and the screen ratio changesto 16:9. When the ASPECT button is pressed while lit, thelight goes off and the normal screen is restored.NOTE: This function is invalid with the RGB-input screen.AREA MARKER button/lampWhen the AREA MARKER button is pressed while thescreen ratio is 16:9, the button lights and the whitemarker is displayed. This shows the screen size (area)set on the menu. When the AREA MARKER button ispressed while lit, the light goes off and the normal screenis restored.NOTE: This function is invalid with the RGB-input screen.– INPUT SELECT buttons/lampsPress the unlit button. The button lights and the inputsignal is changed. (any other lit button goes off.)When the lit button is pressed, the status of the currentinput signal is displayed (for approx. 3 seconds). ButtonsA through F correspond to the signals input via the inputcards installed in SLOT 1 through SLOT 3.A, B : select the picture from the SLOT 1 input card.C, D : select the picture from the SLOT 2 input card.E, F : select the picture from the SLOT 3 input card.12MAKESLOT1RS-232CREMOTESLOT2SLOT3MAIN POWER2425262728Refer to pages 8 and 9 for correspondence between theinput terminals and the INPUT SELECT buttons.Power lampUnlit : The main power is OFF.Orange : The main power is ON, but the monitor’s poweris OFF (in stand-by mode).Green : The main power is ON, and the monitor’s poweris ON (in normal operation mode).POWER switchPress the power switch to turn the monitor’s power ON orOFF when the main power is ON.NOTE: When RUSH DELAY TIME is set to MODE 2 inthe set-up menu, it takes approx. 3.2 seconds forthe power to actually turn ON after the powerswitch is pressed.REMOTE (external control) terminalsTerminals for controlling the monitor from an external unit.MAKE terminal (Upper):Enables the monitor to be controlled by closing the circuit(point of contact) connected to the terminal.RS-232C terminal (Lower):Enables the monitor to be controlled from a personalcomputer via serial communication.Input card slots (SLOT 1 — SLOT 3)Optional input cards can be installed in these slots. Inputcards are not provided when you purchase the monitor.NOTE: It is not possible to input video or audio signals tothe monitor when no input cards are installed.Main power switchPress the switch to turn the main power ON or OFF.When the main power is ON, the power lamp on the frontpanel lights in yellow and the monitor enters the stand-bymode.I : ON : OFFAC inletPower input connector. Connect the provided AC powercord to an AC outlet (120 V/230 V AC, 50 Hz/60 Hz).Built-in speaker (monaural)Outputs the input audio.13141516 2122232425262728[5
