E-26ENGLISHIf you use rack-mounting adaptors BT-MA1710G (optional) with this monitor, you can incorporate a 19-inchstandard rack (the height is 7U size). Please see the instructions below for attachment.1. Remove the screws on the back and base of themonitor (3 places), and remove the stand.2. Using the screws provided, attach the rack-mounting adaptors to both sides of the monitor.Error/Warning DisplaysIf for any reason an error occurs in this monitor, the LEDs above the picture adjusting knob flash at 1-secondintervals (informing you of the error/warning display).Maintenance• To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out toclean the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor cancause a malfunction.• Never use thinner or benzene to clean this unit.Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.• Do not spray cleansers directly onto the monitor.Water or similar substances getting inside the monitor can cause a malfunction.ScrewRear viewBaseStandRack-mounting adaptorScrewError/Warningdisplays Symptom SolutionInverter error If a malfunction occurs in the inverter thatcontrols the backlight brightness, thebacklight will switch OFF.The screen becomes completely black.Switch the power supply OFF once, thenswitch it back ON again. If an error is stilldisplayed, contact the vendor where youpurchased the monitor.Fan stopErrorThe fan in the back of the monitor stops ifa malfunction occurs. If a picture is beingdisplayed when the malfunction occurs, itwill continue being displayed as is.If the error is still displayed after this,contact the vendor where you purchasedthe monitor immediately.If a fan stop error occurs, setting “FANMOTOR” to “OFF” in the “SYSTEMCONFIG” menu (refer to page E-17)allows you to continue using the monitorwith reduced screen brightness.How to Attach the Rack mounting