Panasonic C3403U Operating Instructions Manual

Panasonic C3403U Operating Instructions Manual Manual pdf 9 page image

98ENGLISHCQ-C3433U/C3403U/C3333U/C3303UPreparationWarning¡Keep a battery away from children to avoid the risk ofaccidents. If an infant ingests a battery, please seekimmediate medical attention.Caution¡Remove and dispose of an old battery immediately.¡Do not disassemble, heat or short a battery. Do notthrow a battery into a fire or water.¡Follow local regulations when disposing of a battery.¡Improper use of a battery may cause overheating, anexplosion or ignition, resulting in injury or a fire.Note:¡Battery Information:Battery Type: Panasonic lithium battery (CR2025)(Included in the remote control)Battery Life: Approximately 6 months under normal use(at room temperature)The demonstration message appears for initialuse.q Set your car’s ignition switch to the ACC or ON position.The demonstration screen appears.w Press [SRC/PWR] to turn on the power.e Press and hold [VOLUME] (PUSH SEL) for morethan 2 seconds to open the menu.r Press [VOLUME] (PUSH SEL) to select theDemonstration setting. (“DEMO” is displayed.)t Turn [VOLUME] counterclockwise. (Press [0] ({) onthe remote control unit.)Note:¡ To return to the regular mode, press [D] (DISP).¡ Refer to the section on “Function Settings”.(a Page 22)Remote Control UnitMain UnitThe 12-hour system is used for the clock.q Press [SRC/PWR] to turn on the power.w Press [D] (DISP/CLOCK).Clock displaye Press and hold [D] (DISP/CLOCK) for more than 2seconds.Hour blinksr Adjust the hour.[[]: put forward hour.[]]: put back hour.Hour enteredt Press [D] (DISP/CLOCK).Minute blinksy Adjust the minute.[[]: put forward minute.[]]: put back minute.Minute enteredu Press [D] (DISP/CLOCK).CompletedNote:¡“ADJUST” is displayed before adjusting the clock.¡Press and hold [[] or []] to change numbers rapidly.Cancellation of Demonstration Clock Setting[SRC/PWR] (Power)[D] (DISP/CLOCK)[]] [[](Hour/minute adjustment)Preparation Before Initial UsePull the insulation film out from thebackside of the remote control gently.Battery Replacementq Remove the battery holder with theremote control unit placed on a flatsurface.q Stick your thumbnail into thegroove and push the holder in thedirection of the arrow at the sametime.w Pull it out in the direction of thearrow using a tough pointed object.w Put a battery in the case with (+) sidefacing up.e Put the case back.Tough pointedobjectBack side[VOLUME](PUSH SEL: select)