56List of Error CodesThe following is a list of the messages that BIOS can display. Most of them occur during POST. Someof them display information about a hardware device, e.g., the amount of memory installed. Othersmay indicate a problem with a device, such as the way it has been configured. Following the list areexplanations of the messages and remedies for reported problems.If your system displays one of except the messages marked below with an asterisk (*), write down themessage and contact Panasonic Technical Support. If your system fails after you make changes in theSetup menus, reset the computer, enter Setup and install Setup defaults or correct the error.0200 Failure Fixed DiskFixed disk in not working or not configured properly. Check to see if fixed disk is attached properly. Run Setup. Find outif the fixed-disk type is correctly identified.0210 Stuck keyStuck key on keyboard.0211 Keyboard errorKeyboard not working.0212 Keyboard Controller FailedKeyboard controller failed test. May require replacing keyboard controller.0213 Keyboard locked - Unlock key switchUnlock the system to proceed.0230 Shadow RAM Failed at offset :nnnnShadow RAM failed at offsetnnnn of the 64k block at which the error was detected.0231 System RAM Failed at offset :nnnnSystem RAM failed at offsetnnnn of in the 64k block at which the error was detected.0232 Extended RAM Failed at offset :nnnnExtended memory not working or not configured properly at offsetnnnn.0250 System battery is dead - Replace and run SETUPThe CMOS clock battery indicator shows the batter y is dead. Replace the battery and run Setup to reconfigure thesystem.*0251 System CMOS checksum bad - Default configuration usedSystem CMOS has been corrupted or modified incorrectly, perhaps by an application program that changes datastored in CMOS. The BIOS installed Default SETUP Values. If you do not want these values, enter Setup and enteryour own values. If the error persists, check the system battery or contact Panasonic Technical Support.0260 System timer errorThe timer test failed. Requires repair of system board.0270 Real time clock errorReal-time clock fails BIOS test. May require board repair.*0280 Previous boot incomplete - Default configuration usedPrevious POST did not complete successfully. POST loads default values and offers to run Setup. If the failure wascaused by incorrect values and they are not corrected, the next boot will likely fail. On systems with control of waitstates, improper Setup settings can also terminate POST and cause this error on the next boot. Run Setup and verifythat the wait-state configuration is correct. This error is cleared the next time the system is booted.0281 Memory Size found by POST differed from CMOSMemory size found by POST differed from CMOS.02B0 Diskette drive A error02B1 Diskette drive B errorDrive A: or B: is present but fails the BIOS POST diskette tests. Check to see that the drive is defined with the properdiskette type in Setup and that the diskette drive is attached correctly.02B2 Incorrect Drive A type - run SETUPType of floppy drive A: not correctly identified in Setup.02B3 Incorrect Drive B type - run SETUPType of floppy drive B: not correctly identified in Setup.02D0 System cache error - Cache disabledContact Panasonic Technical Support.02F0: CPU ID:CPU socket number for Multi-Processor error.02F4: EISA CMOS not writableServerBIOS2 test error: Cannot write to EISA CMOS.