If a new plug is to be fitted please observe the wiring code asshown below.If in any doubt please consult a qualified electrician.Warning: THIS APPLIANCE MUST BE EARTHED.ImportantThe wires in this mains lead are coloured in accordance with thefollowing code:Green-and-yellow: EarthBlue: NeutralBrown: LiveAs the colours of the wires in the mains lead of this apparatusmay not correspond with the coloured markings identifying theterminals in your plug, proceed as follows:The wire which is coloured GREEN-and-YELLOW must be con-nected to the terminal in the plug which is marked by the letterE or by the safety earth symbol coloured GREEN or GREEN-and-YELLOW.The wire which is coloured Blue must be connected to the ter-minal which is marked with the letter N or coloured BLACK.The wire which is coloured Brown must be connected to theterminal which is marked with the letter L or coloured RED.The mains plug on this equipment must be used to disconnectthe mains power.Please ensure that a socket outlet is available near the equip-ment and shall be easily accessible.How to replace the fuseOpen the fuse compartment with ascrewdriver and replace the fuse.WarningsThis equipment is not designed for connection to an IT powersystem.(An IT system is a system having no direct connectionsbetween live parts and Earth; the exposed-conductive-partsof the electrical installation are earthed.An IT system is not permitted where the computer is directlyconnected to public supply systems in the U.K.)Disconnect the mains plug from the supply socket when thecomputer is not in use.This equipment is produced to BS800/1983.8-E-1For U.K.WarningThis apparatus must be earthed for your safety.To ensure safe operation the three-pin plug must be insertedonly into a standard three-pin power point which is effectivelyearthed through the normal household wiring.Extension cords used with the equipment must be three-coreand be correctly wired to provide connection to earth. Wronglywired extension cords are a major cause of fatalities.The fact that the equipment operates satisfactorily does not im-ply that the power point is earthed and that the installation iscompletely safe.For your safety, if you have any doubt about the effectiveearthing of the power point, consult a qualified electrician.FOR YOUR SAFETY PLEASE READ THE FOLLOWINGTEXT CAREFULLYThis appliance is supplied with a moulded three pin mains plugfor your safety and convenience.A 3 amp fuse is fitted in this plug.Should the fuse need to be replaced please ensure that the re-placement fuse has a rating of 3 amps and that it is approved byASTA or BSI to BS 1362.Check for the ASTA mark A S Aor the BSI mark on the bodyof the fuse.If the plug contains a removable fuse cover you must ensurethat it is refitted when the fuse is replaced.If you lose the fuse cover the plug must not be used until areplacement cover is obtained.A replacement fuse cover can be purchased from your localPanasonic Dealer.IF THE FITTED MOULDED PLUG IS UNSUITABLE FORTHE SOCKET OUTLET IN YOUR HOME THEN THE FUSESHOULD BE REMOVED AND THE PLUG CUT OFF ANDDISPOSED OF SAFELY.THERE IS A DANGER OF SEVERE ELECTRICAL SHOCKIF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMPSOCKET.OPERATING INSTRUCTIONSBEDIENUNGSANLEITUNGINSTRUCTIONS D’UTILISATIONAC AdaptorModel No. CF-AA5803A© 2008 Matsushita Electric Industrial Co., Ltd. All Rights Reserved.DFQW5203ZA HS0608-0Printed in Japan