CQ-C3405U/C3305U12 CQ-C3405U/C3305U 13 EnglishGeneral, Sound ControlSQ Selection Based on GenreSQ (Sound Quality)The equalizer curve is selectable from among 4 types(FLAT, ROCK, POP and VOCAL) depending on yourlistening category.SQ changeoverThe SQ category is changed every time [SQ] (SoundQuality) is pressed.(FLAT) fl at frequency response:does not emphasize any part.(Default)(ROCK) speedy and heavy sound:exaggerates bass and treble.(POP) wide-ranged and deep sound:slightly emphasizes bass and treble.(VOCAL) clear sound:emphasizes middle tone and slightlyemphasizes treble.Press [DISP] to return to the regular mode.Notes:• Setting of SQ, bass/treble and volume are infl uencedone another. If such an influence mentioned abovecauses distortion to the audio signal, readjust bass/treble or volume. ( page 22)• Please refer to page 22 for the adjustment to eachspeaker and an optional subwoofer.· Bass adjustment· Treble adjustment· Balance adjustment· Fader adjustment· Subwoofer level adjustmentSource Selection(SOURCE)The source changes as follows every time [SOURCE]is pressed.AUX1 (AUX1 in) (3.5 mm stereo)From line output of external sound/audio device (ex.Silicon-audio player, HDD player, etc.)GeneralVolume off (down)Press [MUTE].CancelPress [MUTE] again.Note: You can select mute or attenuation. ( page 23) Up DownSetting Range: 0 to 40Default: 18Note: The volume level can be set independently foreach source. (For radio, one volume setting for AM, onevolume setting for all FMs)VolumeAdjustment(VOLUME)Temporary Volume Off(Down)MUTE (ATT: Attenuation)RadioFM1, FM2, FM3, AM ( page 14)PlayerWhen loading CD ( page 16)When loading MP3/WMA disc ( page 18)AUX1Device connected to the AUX1 terminal of this unitSound ControlCaution• Set the volume level to low enough before theAUX connection is completed.Failure to observe this, the loud noise may comeout and damage your speakers and your hearing.When an optional device is connected:Shift to connected deviceWhen connecting CD changerWhen connecting iPodWhen connecting XM ReceiverWhen connecting Sirius ReceiverORWhen an expansion module is connected:The devices connected to the ports 1 to 4 areactivated in sequence after shifting to AUX2 (deviceconnected to the AUX terminal of the expansionmodule).Note: For information about connectable devices,refer to the System Upgrade Guidebook or theinstruction manual for each device.System-up Connector