Panasonic CQ-C5301U Operating Instructions Manual

Also see for CQ-C5301U: Operating instructions Operating instructions Operating instructions Installation instructions

Contents

Panasonic CQ-C5301U Operating Instructions Manual Manual pdf 8 page image

Display ChangePress [DISP] to change the display as follows.Note:¡ “UPDATING” is displayed when channel information isupdated.Channel PresetUp to 6 channels can be stored in each of the XM1, XM2and XM3 band selections.With this operation, a channel can be manually stored inthe preset memory.q Select a band and channel. (a Previous page)w Press and hold one of the preset buttons from [1] to [6]until the display blinks once.Note:¡ New channels overwrite existing saved channel afterthis procedure.Preset Channel Callingq Select a band. (a Previous page)w Press one of the preset buttons from [1] to [6].Note:¡ Because preset memory setting is performed withService IDs in each channel, a channel may switch toanother that has been stored under the same ServiceIDs when calling up a preset channel. However, broad-casting contents are the same as what the stored chan-nel provides.Category SettingPress and hold [BAND] for more than 2 seconds toswitch category mode ON or OFF.(Category mode ON)¡ Enables category switching.¡ Enables channel selection only within the catego-ry selected by category switching.Category Selectionq Press [}] or [{] to display the category name. (CATON)w Press [}] or [{] while the category name is dis-played to select a category. Seeking will start.Direct Channel Selection(Only for remote control unit)Example: Channel number 5q Press [#].w Press [5]e Press [BAND] (SET).Note:¡ The previous screen reappears if a nonexistent channelis selected.¡ “OFF AIR” is displayed and the previous screen reap-pears in a few seconds if an off-the-air channel isselected.1716ENGLISHCQ-C5401U/C5301U1615ENGLISHCQ-C5401U/C5301UXM Satellite RadioArtist nameChannel name( ) (Data loading)( ) (Data loading)Display OffSong title( ) (Data loading)Category name( ) (Data loading)Clock Time[SRC: Source][DISP] (Display)[]] [[](Channel Selection)[{] / [}](Category Selection)[BAND](Band/Category Setting)Band/Channel(Default)Preset Buttons [1] to [6](Channel station)Preparation:¡ Connect the optional XM receiver (XMD1000) withoptional Digital Adapter (XMDPAN100).Getting StartedIt is required to sign up to become an XM Satellite Radiosubscriber. After checking your XM Satellite Radio ID, signup on the XM’s website or by calling them.q Check of XM Satellite Radio ID¡ Write down the ID indicated on the lower right of yourXM receiver (XMD1000).¡ Check the ID shown by tuning your XM Radio to chan-nel 0. (Refer to “Channel Selection” on this page.)(RADIO ID display)w Activate the XM Satellite RadioSelect either of the below to sign up.¡ Web site: http://www.xmradio.com/activation¡ Phone number: 1-800-852-9696q XM Satellite Radio ModePress [SRC] to select the XM Satellite Radiomode.Note:¡ “LOADING” is displayed when it takes more than 2 sec-onds to receive the XM Satellite Radio.w BandPress [BAND].e Channel Selection[[]: Higher channel[]]: Lower channelNote:¡ Channel selection is not available during the reception ofchannel 1 with category ON. To receive other channels, set thecategory to OFF or switch to another category. (a Nextpage)XM RADIO IDXMD 1000L/C 1144XXXXXX XM RADIO ID : XXXXXXXXBand Channel(Satellite) indicatorappears at category mode ON