Panasonic CQ-C7703N Operating Instructions Manual

Also see for CQ-C7303N: Brochure & specs Operating instructions Installation instructions Operating instructions Service manual

Panasonic CQ-C7703N Operating Instructions Manual Manual pdf 26 page image

y / 5 Pause/Play(a page 24, 26)BAND (a page 18)SET (a page 31, 32)APM Auto Preset Memory(a page 19)8Controls LayoutNote: This instruction manual explains operations for use with the buttons on the main unit. (Different operations excluded)CQ-C7703N/C7303NSRC Source (a page 14)PWR Power (a page 12)SQ Sound Quality(a page 17)MENU (a page 31, 32)VOLUME (a page 13)PUSH SEL Select(a page 30)SRS WOW (a page 16)D (DISP) Display (a page 15)PTY Programme Type (a page 17)TUNE (a page 18)TRACK (FILE)(a page 22, 24)Release (a page 12)u (eject) TILT (a page 13)OPEN (a page 13)Main UnitDisc slotP·SET Preset (a page 19)DISC (a System UpgradeGuidebook)FOLDER (a page 26)MUTE (a page 13)SBC-SW (a page 17)TA Traffic Announcement(a page 22)AF Alternative Frequency(a page 21)When Face PlateOpensRemote control sensorDownloaded from Caradio-Manual.com ManualsPower onPress [SRC] (PWR: POWER).Power offHold down [SRC] (PWR: POWER) untilyou hear a beep, then release it.12GeneralThis chapter explains how to turn on or off the power, how to adjust the volume, etc.CQ-C7703N/C7303NYou can remove the faceplate to prevent it frombeing stolen.Removing1 Turn off the power (a page 12)2 Press [ ](Release).(The face plate disen-gages with a clickwhen it is removed.)The face plate automatically closes after a lapse of 5seconds while it is open.The power is automatically turned off while the unitis active.3 Put the faceplate in the case.Mounting1 Slide the left side of the face plate inplace.2 Press the right end of the face plateuntil “click” is heard.Cautions:¡ It is recommended to remove or mount the faceplate when the plate is at the closed position.Do not remove or mount the face plate when theplate is in motion.¡ This face plate is not waterproof. Do not expose it towater or excessive moisture.¡ Do not remove the face plate while driving your car.¡ Do not place the face plate on the dashboard ornearby areas where the temperature rises to highlevels.¡ Do not touch the contacts on the face plate or on themain unit, since this may result in poor electricalcontacts.¡ If dirt or other foreign substances get on the con-tacts, wipe them off with clean and dry cloth.¡ To avoid damaging the face plate, do not push itdown or place objects on it while it is open.Power On/off(PWR: POWER)Face Plate Removing/Mounting(ANTI-THEFT SYSTEM)Downloaded from Caradio-Manual.com Manuals14GeneralCQ-C7703N/C7303NRadioFM1, FM2, FM3, AM (LW/MW) (a page 18)Source Selection(SOURCE)The source changes as follows every time [SRC](SOURCE) is pressed.PlayerWhen loading CD (a page 24)When loading MP3/WMA disc (a page 26)AUX 1Device connected to the AUX terminal of the this unitAt connecting to other than a TVAt connecting to a TV(only for CQ-C7703N a page 34)System-up ConnectorDevice connected to the System-up Connector of thisunitWhen optional devices are connected:Shift to connected devicesWhen an expansion module is connected:The devices connected to the ports 1 to 4 are activatedin sequence after shifting to AUX2 (devices connectedto the AUX terminal of the expansion module).When connecting DVD ChangerWhen connecting CD ChangerWhen connecting iPodNote: For information about connectable devices, referto the System Upgrade Guidebook or the instructionmanual for each device.When connecting Expansion ModuleDownloaded from Caradio-Manual.com Manuals16Sound ControlCQ-C7703N/C7303NSRS WOWSRS WOW Setting(SRS WOW Menu Display)SRS WOW TM is 3-D sound technology based on the HRTF(Head Related Transfer Function) theory. Unlikeconventional audio systems, “natural 3-D sound field”,“rich bass”, and “crisp and clear sound” can be obtainedat the same time in a wide area in front of speakers.Holding down [VOLUME] (SRS WOW) for 2 sec. ormore toggles SRS WOW on and off.Note: If you enable SRS WOW, the following functionsare automatically disabled:SQ, BASS/TREBLE, BALANCE/FADER, HPF, SBC-SW Lights when SRS WOW is activated.You can make a fine adjustment to SRS WOW.1 Set the SRS WOW mode to on.2 Hold down [SQ] for 2 sec. or more todisplay the audio menu display.3 Press [}] or [{] to select a function tobe adjusted.4 Press [BAND] (SET) to adjust.5 Press [D] (DISP: DISPLAY) to confirmthe adjustment.SRS TruBass ®: Deep bass enhancement by application of thebass reproduction technique of a pipe organ(default): No enhancementSRS FOCUS®Sound image movement in a vertical direction to makesound crisp: high (default): low: offSRS ®: Surround function on (default): Surround function offis a trademark of SRS Labs, Inc.WOW technology is incorporated under license fromSRS Labs, Inc..Downloaded from Caradio-Manual.com Manuals24CD PlayerCQ-C7703N/C7303NWhen a disc is already loaded, press [SRC] (SOURCE)to select the CD mode.1 Press [u] (OPEN) to open the faceplate.When a disc is already loaded ( lights), the discwill automatically be ejected.2 Load a disc with the printed side facingup.The face plate closes automatically, and the unit rec-ognizes the disc and starts playing automatically,too.Note: The panel automatically closes after 20 sec-onds.3 Select a desired portion.Track selection[7] (TRACK): Next track[6] (TRACK): Preceding track (press twice)Note: Hold down for fast forward/reverse.PausePress [BAND] (h / 5).Press again to cancel.4 Press [u] (OPEN) to eject the disc.Track number TimeLights when the disc isloaded.Play Mode indicatorsLights when each mode isactivated.CD-TEXT displayNotes:¡ For scrolling text, hold down [D] (DISP: DISPLAY)for 2 sec. or more.¡ “NO TEXT” is displayed when there is no informationon the disc.Operation FlowCD Mode DisplayPrinted sideDownloaded from Caradio-Manual.com Manuals26MP3/WMA PlayerCQ-C7703N/C7303NOperation FlowWhen a disc is already loaded, press [SRC] (SOURCE)to select the MP3/WMA mode.1 Press [u] (OPEN) to open the faceplate.When a disc is already loaded ( lights), the discwill automatically be ejected.2 Load a disc with the printed side facingup.The face plate closes automatically, and the unit rec-ognizes the disc and starts playing automatically,too. (It may take several minutes to start for a discthat has a lot of files.)Note: The panel automatically closes after 20 sec-onds.3 Select a desired portion.Folder selection[}] (FOLDER): Next folder[{] (FOLDER): Preceding folderFile selection[7] (TRACK): Next file[6] (TRACK): Preceding file (press twice)Note: Hold down for fast forward/reverse.PausePress [BAND] (h / 5).Press again to cancel.4 Press [u] (OPEN) to eject the disc.MP3/WMA Mode DisplayFolder numberTimeLights when the disc isloaded.Play Mode indicatorsLights when each mode isactivated.Information DisplayNotes:¡ For scrolling text, hold down [D] (DISP: DISPLAY)for 2 sec. or more.¡ “NO TEXT” is displayed when there is no informationon the disc.¡ ID3/WMA tag information is displayed for the albumname and title/artist name.File numberFile type indicator(Folder Random)(Folder Repeat)(Folder Scan)Printed sideDownloaded from Caradio-Manual.com Manuals30Audio SettingAdjustment to each speaker and an optional subwooferCQ-C7703N/C7303NMain volume adjustment(Setting range: 0 to 40, Default: 18)q : Upw : DownBass adjustment(Setting range: -12 dB to +12 dB, 2 dB Step, Default:Bass 0 dB)q : Upw : DownTreble adjustment(Setting range: -12 dB to +12 dB, 2 dB Step, Default:Treble 0 dB)q : Upw : DownNote: Do not activate SQ and Bass/Treble at same timeto avoid causing sound distortion.Balance adjustment(Setting range: L (left)15 to R (right) 15 and Centre,Default: Center)q : Right enhancedw : Left enhancedFader adjustment(Setting range: R (rear) 15 to F (front) 15 and Centre,Default: Center)q : Front enhancedw : Rear enhancedSubwoofer level adjustment(Setting range : mute (- ), -6 dB to +6 dB, 2 dB Step,Default: 0 dB )q : Upw : DownSubwoofer Low Pass Filter(Setting range: 80 Hz, 120 Hz, 160 Hz, Default: 80 Hz)q : Upw : DownHigh Pass Filter(Setting range: Filter OFF, 90 Hz, 135 Hz, 180 Hz, 225 Hz,Default: Filter OFF)q : Upw : DownRear Level Adjustment (SRS WOW)(Setting range: 0 to –15, Default: –10)q : Upw : DownNote: The rear level is adjustable only when SRS WOWis enabled. (a page 16)Subwoofer output rangeOther speakers output rangesAUDIO Menu Display1 Press [VOLUME](PUSH SEL:SELECT) to dis-play the AUDIOmenu display.2 Press [VOLUME] (PUSH SEL:SELECT) to select a mode to be adjust-ed.3 Turn [VOLUME]clockwise orcounterclockwiseto adjust.Notes:¡ If no operation takes place for more than 10 secondsin the audio menu (2 sec. in Main volume adjust-ment), the display returns to the regular mode.¡ Only the main volume, subwoofer level, subwooferlow pass filter, and rear level are adjustable when SRSWOW is enabled. (a page 16)qwDownloaded from Caradio-Manual.com Manuals32Display SettingAdjustment to display on the DISPLAY menuCQ-C7703N/C7303NDISPLAY Menu Display1 Press [MENU] to display the menudisplay.For using the remotecontrol, hold down[SEL] (MENU) for 2sec. or more.2 Press []] or [[] to display theDISPLAY menu.3 Press [}] or [{] to select a function tobe adjusted.4 Press [BAND](SET) to confirmthe display.5 Adjust the setting value.6 Press [BAND] (SET).7 Press [MENU] to confirm theadjustment.For using the remote control, hold down [SEL](MENU) for 2 sec. or more.COLOR(Setting range: 10 types, default: STORM)The illumination color changes as follows.Switching by [}] or [{]STORM: The color varies in conjunction with time.LEVEL: The peripheral color decoration lights up andgoes out according to the bass volume.FIRE: RedORANGE: AmberSKY: BlueOCEAN: AquablueFOREST: GreenSUN: YellowSNOW: WhiteCUSTOM: You can create your favorite color.LEVEL ADJ[]][[]: Function selection[}][{]: Item selectionColor selectionThe illumination color changes.(Setting range: FIRE, ORANGE, SKY, OCEAN, FOREST,SUN, default: FIRE)Volume setting according to lighting(Setting range: LEVEL1, LEVEL2, LEVEL3, default: LEVEL1)If the peripheral color decoration keeps lighting becausethe bass part is contained abundantly, select LEVEL 1,and for the opposite case, select LEVEL 3.DEMONSTRATIONSwitching by [BAND].ON: Demonstration screen at no operation(default)OFF: Regular screenDownloaded from Caradio-Manual.com Manuals