10 CQ-CB9900U CQ-CB9900U 11VolumeNote:≥ The volume level can be set independently foreach source (for radio, one volume setting forAM, one volume setting for all FMs).Setting range: 0 to 40(default: 18)[VOL "]: Up[VOL #]: DownDownUpGeneralSourcePowerTurn your car’s ignition keyto the ACC or ON position.ON: Press [SOURCE] (PWR).OFF: Press [SOURCE] (PWR) again and hold formore than 1 second.Press [SOURCE] (POWER) again and holdfor more than 1 second.Note:≥ After turning off the ignition key, a securitymessage is displayed, and the panel removablealarm that reminds you to take the panel isactivated.(When security function is set to on, page 38)ACCONDemonstration:When the power is switched on for the fi rst time,a demonstration appears on the display.Press [DISP] (display) to change to regularmode.Note:≥ To display the demonstration again, press andhold [SOURCE] for more than 4 seconds whenturning power on.64975Car AudioSOURCEMUTEPOWERRANDVOL31 2DISPBANDREP6 5SETSEL#SCANMENUNUMBER80 [DISP](Display)[SOURCE](Power/source)[MUTE](Mute/attenuation)(SBC-SW)[VOL "][VOL #](Volume)[SOURCE](PWR: Power)Press [SOURCE] to change the source.[MUTE] (Mute/attenuation)(SBC-SW)[VOLUME][DISP] (Display)Point the remote control unit at the remote control signal sensor.Rear Speakers as Sub-Woofers(Super Bass Control Subwoofer/SBC-SW)You can utilize the rear speaker connected to thebuilt-in amplifi er as Sub-Woofers that output onlybass. (Default: OFF)Press and hold [MUTE] (SBC-SW) for more than2 seconds.When a CD is in the player.Radio (page 14)CD player (page 19)When a MP3 data disc is inthe player.MP3 player (page 22)When an optional CD changeris connected.CD changer control (page 28)AUX (page 57)orWhen a WMA data disc isin the player.WMA player (page 22)orOFF (default)ONNote:≥ When ON has been selected, the settings resultingfrom the adjustments performed at the subwooferlevel and subwoofer low pass fi lter settings arerefl ected in the output.≥ Depending on the speakers used and the type ofmusic played, it may not be possible to achieve asatisfactory effect.lights.Mute/AttenuationON: Press [MUTE].OFF: Press [MUTE] again.You can select mute or attenuation (page 38).No sounds. (default)Decrease the volume by 10 steps.DimmerPress and hold [MENU] (DIM) for more than2 seconds to change dimmer level setting asfollows.Brighter (default)MediumDarker[MENU] (DIM)