ENGLISH9CQ-DF302W18Remote Control Unit PreparationBattery Installation1 Remove the battery holder.Pull the holder by the position B while pushing posi-tion A in the direction indicated by the arrow.2 Install the battery on the battery holder.Set a new battery properly with its (i) side facing upas shown in the figure.3 Insert the battery holder.Push in the battery holder back into its original posi-tion.Battery NotesRemove and dispose of an old battery immediately.Battery Information:≥ Battery type: Panasonic lithium battery (CR2025) (included)≥ Battery life: Approximately 6 months with normal use (at room temperature)Back sideLithium battery(included)Battery holder Position APosition B≥ Do not disassemble or short the battery. Do not throw a battery into a fire.≥ Keep batteries away from children to avoid the risk of accidents.≥ Be careful to the local disposal rules when you dispose of batteries.Control Reference GuideButtons of the remote control function in the same way as the controls on the main unit of the reference page.Point the remote control unit at the main unit’s sensor (REMOTE).Mute button (MUTE)(➡ page 10)Volume control buttons(VOL " #)(➡ page 10)Tune, Track buttons(TUNE % $, TRACK 6 5)(➡ pages 14, 16)Power button (PWR)(➡ page 10)Mode button (MODE)(➡ pages 14, 16)Caution:≥ Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.Battery leakage may damage the unit.PWRMODEPRGTUNETRACKCar AudioBAND/DISC UPVOLMUTE(ATT)Band/Disc up* button(BAND/DISC UP*)(➡ pages 14, 17)*Only for CD changercontrol(When the CD changeris connected.)