PanasonicPanasonicLeft Speaker(Rear) Right Speaker(Rear)(–) (+) (–) (+) (–) (+) (–) (+)Left Speaker(Front) Right Speaker(Front)(White) (Violet/blackstripe)(Gray)(Gray/blackstripe)(White/blackstripe) (Green/blackstripe)(Green) (Violet)BATTERY 15AFRONT SP REAR SPACCAntennaPre-Amp outputconnector (Rear) CD changer input connectorCD changer controlconnectorBattery leadTo the car battery,continuous +12 V DCACC power leadTo ACC power,+12 V DC(Yellow) Fuse (15 A)Resistor (1 kΩ)(Red)(Black)(Blue)(Blue/white stripe)y Power connectorGround leadTo a clean, bare metallic part of the carchassis.Motor antennarelay control lead(To motor antenna) (Max. 500mA)This lead is not intended for use with switch actuatedpower antenna.Note: The power antenna extends automatically whenthe radio mode is selected. Speaker leadL (White)R (Red)External amplifier control lead (Max. 500 mA)This lead is for connection to the power amplifier.Note: This lead is used for power control whenan external power amplifier is connected. Thepower supply of a power amplifier will beactivated when turning on the power of this unit.30 CQ-DP171U21ENGLISH Cautions:¡This product is designed to operate off a 12 V DC, negative ground battery system.¡To prevent damage to the unit, be sure to follow the connection diagram below.¡Remove approx. 1/4” (5 mm) of protective covering from the ends of the leads before connecting.¡Do not insert the power connector into the unit until the wiring is completed.¡Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keepcable terminals free from touching any metal parts.¡Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased whenthe battery terminals are disconnected.Electrical ConnectionsAccessory used for wiringNo. Item Q’tyy Power connector 1❏ Wiring Diagram