Panasonic CQ-DPX101U Operating Instructions Manual

Contents

Panasonic CQ-DPX101U Operating Instructions Manual Manual pdf 13 page image

ENGLISH16CQ-DPX151/DP101U 25TroubleshootingENGLISH15CQ-DPX151/DP101U24Electrical Connections❐ Wiring DiagramNo. Item Q’ty6 Power connector 1Power connectorAntenna6Yellow Battery leadTo the car battery,continuous +12 V DCFuse (15 A)Red Power leadTo ACC power,+12 V DCDark blue/white stripeDark blueMotor antennarelay control lead(To motor antenna) (Max. 500 mA)This lead is not intended for use with switchactuated power antenna.BlackGround leadTo a clean, bare metallic part of car chassis.rsrsrs rsLeft speaker(Front)Right speaker(Front)White Gray Green VioletWhite/blackstripeGreen/blackstripe Violet/blackstripeGray/blackstripeFRONT SP REAR SPLeft speaker(Rear)Right speaker(Rear)Speaker leadPre-Amp output connector (Front)Pre-Amp output connector (Rear)L (White)R (Red)Only for CQ-DPX151UCQ-DPX151/DP101UAmp. relay controlpower lead(Max. 500 mA)This lead is for connectionto the power amplifier.BATTERY15AACCIf the fuse (rear panel) blows frequently,they may be something wrong with the unit.Consult your nearest Panasonic Servicenterfor service.§§Cautions:≥ This product is designed to operate of a 12 V DC, negative ground battery system.≥ To prevent damage to the unit, be sure to follow the wiring diagram below.≥ Remove approx. 1⁄4z (5 mm) of protective covering from the ends of the leads before connecting.≥ Do not insert the power connector into the unit until the wiring is completed.≥ Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cablesand keep cable terminals free from touching any metal parts.≥ Remember, if your car has a drive computer or a navigation computer, the data of its memory may beerased when the battery terminals are disconnected.Preliminary StepsCheck and take steps as described in the tables below.If You Suspect Something WrongImmediately switch power off.Disconnect the power connector and check that there is nei-ther smoke nor heat from the unit before asking for repairs.Never try to repair the unit yourself because it is dangerous todo so.No power.TroubleCar’s engine switch is not on.➡Turn your car’s ignition switch to ACC or ON.Troubleshooting Tips❐ CommonCables are not correctly connected.➡Connect cables correctly.Battery cable is not correctly connected.➡Connect the battery cable to the terminal that is always live.Accessory cable is not correctly connected.➡Connect the accessory cable to your car’s ACC source.Grounding wire is not correctly connected.➡Connect the grounding wire to a metal part of the car.Fuse is burnt.➡Call the store where you purchased the unit, or your nearest servicestation (see the attached sheet) and ask for fuse replacement.No sound.Mute is set to ON.➡Set it to OFF.Cables are not correctly connected.➡Connect cables correctly.Condensation (dew)➡Wait for a while before use.Cautions:≥ Do not use the unit if it malfunctions oris something wrong.≥ Do not use the unit in abnormal condi-tion, for example, without sound, orwith smoke or foul smell, can cause ig-nition or electric shock. Immediatelystop using it and call the store whereyou purchased it.Cause/StepAccessory used for wiring❐ RadioMuch noise in FM stereoand monaural broad-casts.Station is too far, or signals are too weak.➡Select other stations of higher signal level.Battery cable is not correctly connected.➡Connect the battery cable to the terminal that is always live.Preset station is reset.Trouble Cause/Step