Panasonic CQ-DPX152U Quick Installation Manual

Also see for CQDPX152U - AUTO RADIO/CD DECK: Operating instructions

Contents

Panasonic CQ-DPX152U Quick Installation Manual Manual pdf 1 page image

ENGLISH2CQ-DPX152/DP102U 11ENGLISH1CQ-DPX152/DP102U10Power and Sound ControlsPowerTurn the key in the ignition until the accessory indica-tor lights.Power on: Press [SOURCE] (PWR).Power off: Press [SOURCE] (PWR) again and hold.MutePress [MUTE] to mute the sound completely.Press [MUTE] again to cancel.Volume[" VOL]: Up[# VOL]: DownPress and hold for rapid adjustment.Volume level (0 to 40)Anti-volume-blast circuit:When the power is switched off and on again, the volume slowly rises to the previous level.The anti-volume-blast circuit will not work when the volume level is set lower than position 20 on the dis-play.<VOLSELBANDTUNEMUTEM/L1 2 3 4 5 6712SOURCEREPCQ-DPX152UCD RECEIVER 45W X4LOUDRANDOMPWR8119 10TRACKDISPMONO/LOCREMOTESCAN/APM<VOLSELBANDTUNEMUTEM/L1 2 3 4 5 6712SOURCEREPCQ-DPX152UCD RECEIVER 45W X4LOUDRANDOMPWR8119 10TRACKDISPMONO/LOCREMOTESCAN/APMAudio Mode(Bass/Treble/Balance/Fader)Regular modeVolume Bass TrebleBalanceFaderNote:≥ If no operation takes place for more than 5 secondsin audio mode (2 seconds in volume mode), the dis-play returns to the regular mode.Bass:Adjustable range: j12 to i12 (by 3 step)Treble:Adjustable range: j12 to i12 (by 3 step)Balance:R (right speaker) or L (left speaker)Fader:F (front speaker) or R (rear speaker)Adjustable range: Balance center1 to 15 (by 1 step)Adjustable range: Fader center1 to 15 (by 1 step)Loudness (Only for main unit)Press [LOUD] to enhance bass and treble tones atlow or medium volume.Press [LOUD] again to cancel.ACCONPress [SEL] to select the audio mode.1Press [" VOL] or [# VOL] to change eachlevel.2Clock BasicsThe 12-hour system is used for the clock.Hours2 Press and hold [DISP] (display) for more than2 seconds.3 Press [% TUNE] or [$ TUNE].Minutes4 Press [DISP] (display).5 Press [% TUNE] or [$ TUNE].6 Press [DISP] (display).Note:≥ Press and hold [% TUNE] or [$ TUNE] tochange numbers rapidly.(Hours blink.)(Hours set.)(Minutes blink.)(Minutes set.)(End.)Initial Time1 Press [DISP] (display).(Clock display.)Time ResetPress and hold [DISP] (display) for more than2 seconds to activate the time setting mode toreset the time.Then, repeat steps 3 to 6.[DISP] (display) [% TUNE], [$ TUNE] (Hours, minutes)MUTELOUD[DISP] (display)Display ChangePress [DISP] (display) to switch to the clock dis-play.When the power is off:No display Clock display