Panasonic CQ-DPX172U Operating Instructions Manual

Also see for CQDPX172U - AUTO RADIO/CD DECK: Operating instructions Service manual

Panasonic CQ-DPX172U Operating Instructions Manual Manual pdf 22 page image

26 CQ-DPX172U17ENGLISHMotor AntennaConnect the car motor antenna lead to the blue motorantenna relay control lead.(Do not confuse the antenna lead with blue/white stripelead for a power amplifier.)BatteryConnect the yellow battery lead to the correct radio wire orto the battery fuse port on the fuse block.AntennaConnect the antenna by plugging the antenna lead into theantenna receptacle.EquipmentConnect any optional equipment such as an amplifier,according to the instructions provided with theequipment. Leave about 12” (30 cm) of distance betweenthe speaker leads/amplifier unit and the antenna/antennaextension cord. Read the operating and installationinstructions of any equipment you will connect to this unit.PowerConnect the red power lead to the correct car radio wire orto the appropriate fuse port on the fuse block.If the stereo unit functions properly with all theseconnections made, disconnect the wires and proceed tothe final installation.❏ Final InstallationLead ConnectionsConnect all wires, making sure that each connection isinsulated and secure. Bundle all loose wires and fastenthem with tape so they will not fall down later. Now insertthe stereo unit into the mounting collar.Congratulations! After making a few final checks, you’reready to enjoy your new auto stereo system.❏ Final Checks1. Make sure that all wires are properly connected andinsulated.2. Make sure that the stereo unit is securely held in themounting collar.3. Turn on the ignition to check the unit for properoperation.If you have difficulties, consult your nearest authorizedprofessional installer for assistance.❏ PreparationInstallation Guide (continued)Less than 30°¡We strongly recommend that you wear gloves forinstallation work to protect yourself from injuries.¡When bending the mounting tabs of the mountingcollar with a screwdriver, be careful not to injure yourhands and fingers.¡Disconnect the cable from the negative batteryterminal (see caution below).¡Unit should be installed in a horizontal position with thefront end up at a convenient angle, but not more than30°.Caution: Do not disconnect the battery terminals of acar with trip or navigational computer since all usersettings stored in memory will be lost. Instead takeextra care with installing the unit to prevent shorts.Dashboard InstallationInstallation Opening7 5 /32 ”(182 mm)2 3 / 32 ”(53 mm)This unit can be installed in any dashboard having anopening as shown above. The dashboard should be 3/16”(4.75 mm) – 7/32” (5.56 mm) thick in order to be able tosupport the unit.