ENGLISH16CQ-R223W 27ENGLISH15CQ-R223W26Speaker ConnectionsCaution: Please follow the instructions given below. Failure to do so will cause damage to the unit and speakers.LR--- -------++++++++ ++-+-+-+ -+-+-+ -+-+LRLRLR(White)(Whitew/black stripe)Chassis(Grayw/black stripe)(Gray)Chassis• Use ungrounded speaker only.• The maximum speaker input should be 50 W or more. (If used with the optionalpower amplifier, the speaker input should be higher than the maximum amplifieroutput.)• The speaker impedance should be 4 - 8 Ω.• This unit uses the BTCL circuit, so each speaker should be connected separatelyusing parallel vinyl insulated cords.• The speaker cords and the power amplifier unit should be kept away (about 30 cmapart) from the antenna and antenna extension cord.• Never connect the speaker cord tothe body of the car.• Do not use a 3-wire type speakersystem having a common earthlead.• Do not connect more than onespeaker to one set of speakerleads.FuseUse fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, orconnecting the unit directly without a fuse, could cause fire or damage to the unit.If the fuse replacement fails, consult your nearest Panasonic Service center.MaintenanceYour product is designed and manufactured to ensure the minimum of maintenance. Use a soft cloth forroutine exterior cleaning. Never use benzine, thinner, or other solvents.TroubleshootingPreliminary StepsCheck and take steps as described in the tables below.If You Suspect Something WrongImmediately switch the power off.Disconnect the power connector and check that there is neithersmoke nor heat from the unit before asking for repairs. Never tryto repair the unit by yourself because it is dangerous to do so.No power.TroubleCar’s ignition switch is not on.➡Turn your car’s ignition switch to ACC or ON.Cables are not correctly connected.➡Connect the cables correctly.Battery cable is not correctly connected.➡Connect the battery cable to the terminal that is always active.Accessory cable is not correctly connected.➡Connect the accessory cable to your car’s ACC source.Grounding wire is not correctly connected.➡Connect the grounding wire to a metal part of the car.Fuse is burnt.➡Call the store where you purchased the unit, or your nearest Servicecenter and ask for fuse replacement.Cautions:• Do not use the unit if it malfunctions or ifthere is something wrong.• Do not use the unit in irregular condition,for example, without sound, or withsmoke or foul smell, which can causeignition or electric shock. Immediatelystop using it and call the shop where youpurchased this unit.Cause/StepTroubleshooting Tips❐ CommonNo sound.Mute is set to ON.➡Set it to OFF.Noise. The ground lead is not connected properly.➡Connect the ground lead properly.Cables are not correctly connected.➡Connect the cables correctly.TroubleNo sound from left,right, front, or rearspeaker.Left and right balance, or front and rear balance is off on one side.➡Adjust BAL/FAD as appropriate.Cables are not correctly connected.➡Connect the cables correctly.The right speaker wire is connected to the left speaker and the left speakerwire to the right speaker.➡Connect the speaker wires to the correct one.Left and right sounds arereversed in stereolistening.Cause/Step❐ Sound Setting
