Panasonic CQ-VD6503N Operating Instructions Manual

Also see for CQ-VD6503N: Brochure & specs

Panasonic CQ-VD6503N Operating Instructions Manual Manual pdf 39 page image

3839CQ-VD6503NEnglish: disables the test tone: enables the test tonedefault:¡When the test tone is set to on, test signal (a continu-ous tone) is output from each speaker for approximately2 seconds.Adjust the output balance so that the tone appears tohave the same volume from each speaker.Adjusting the output balance:Adjust the volume of all of the other speakers to the vol-ume level of the speaker from which the test signalappears to be the quietest.OFFONOFF(Test tone output)TEST TONENote:¡While the privatemode is active, onlyandcan beadjusted.FRONT RFRONT LCROSS OVERCut off frequency: down, : upSetting range: 63 Hz to 200 Hzdefault: 100 Hz: down, : upSetting range: off, 63 Hz to 200 Hzdefault: offNote:¡This setting is not available if is set to .¡ is enabled only on the front speakers(R/L) and rear speakers (L/R).HPF CUT OFFONCS Auto[](High Pass Filter)HPF CUT OFF[](Sub-woofer Low Pass Filter)LPF CUT OFFTIME ALIGNMENT(Delay time setting of each speaker)Adjusting the timing with which the audio from eachspeaker reaches the listener’s position: down, : upSetting range: 0 ms to 5 ms (1 ms steps)1 ms = 0.001 secondsdefault: 0 ms: down, : upSetting range: 0 ms to 15 ms (1 ms steps)1 ms = 0.001 secondsdefault: 0 ms¡Make this adjustment while listening to sound.¡If the speaker setting is for a speaker, thatspeaker cannot be selected.¡When “PRO LOGIC” is displayed, 15 ms are automaticallyadded to the delay time setting for the surround speakers.NONE[](Surround speaker delay timesetting)SUR[](Centre speaker delay time set-ting)CENTERSOURCE LEVELSetting the AV1/AV2 input levelMake this setting if it is not possible to adjust the volumethrough the connected device (on the output side).: sets the level low/sound volume increases: sets the level high/sound volume decreasesdefault:: sets the level low/sound volume increases: sets the level high/sound volume decreasesNote:¡If the input level from AV1/AV2 is too high, the audiowill not be output normally.¡After setting the input levelThe volume can be adjusted by pressing [+] or [–](VOL) on the remote control or turning rotary volumecontroller on the unit.default: HIGHHIGHLOW(Setting for AV2)AV2 LEVELHIGHHIGHLOW(Setting for AV1)AV1 LEVEL