Panasonic CS-A12ATP5 Operating Instructions Manual

Also see for CS-A12ATP5: Service manual

Contents

Panasonic CS-A12ATP5 Operating Instructions Manual Manual pdf 5 page image

4ENGLISHNAME OF EACH PART Remote Control Remote Control Signal.• Make sure it is not obstructed.• Maximum distance : 10 m.• Signal received sound.One long beep or “beep, beep”. Notes for Remote Control.• Do not throw or drop.• Do not get it wet.• Certain type of fluorescent lamps may affectsignal reception. Consult your dealer. Do not place the remote control in a location exposedto direct sunlight, or next to a heating unit, or otherheat source. How to Insert the Batteries1 Gently press the place marked OPEN and slidethe cover towards you.2 Insert the batteries– Be sure the direction is correct About the batteries• Can be used for approximately one year. Observe the following when replacing the batteries• Replace with new batteries of the same type.• Do not use rechargeable batteries (Ni-Cd).• Remove the batteries if the unit is not going to beused for a long period. Proper way to operate the remote control in thecase of ceiling/wall mounting.• Operate the remote control in parallel with the floor.(See the figure below.)1 Signal Transmitter2 Operation Display3 Room Temperature Setting Button(self-illuminating button)4 Operation Mode Selection Button5 Sleep Mode Operation Button(self-illuminating button)6 Timer Setting Button7 Timer Selection Button8 OFF/ON Button(self-illuminating button)9 Fan Speed Selection Button0 Auto Airflow Direction! Timer Set/Cancel Button@ Manual Airflow Direction Selection Button# Reset Point(Press with fine-tipped object to clear the memory)1.5V1.5VOPEN12FANSPEEDCH HOFF ON OFF ONAUTOHEATDRYCOOL"!#$357689421AUTOHEATDRYFANSPEEDOFF/ONTEMPMODE SLEEP FAN SPEEDAUTOMANUALTIMER AIR SWINGOFF/ON SET/CRESETCOOLCH HOFF ON OFF ON• The signal changes as shown in the figure below.It means that the receiving conditions are bad andthe signal can not be controlled properly.O.K.OUT(Fig. 1)(Fig. 2)Horizontal Level