Panasonic CS-E7PKR Service Manual

Also see for CS-E12PKR: Operating instructions

Contents

Panasonic CS-E7PKR Service Manual Manual pdf 71 page image

7111.3 Outdoor Unit11.3.1 Install the Outdoor Unit After selecting the best location, start installation to Indoor/Outdoor Unit Installation Diagram.1 Fix the unit on concrete or rigid frame firmly and horizontally by bolt nut (ø10 mm).2 When installing at roof, please consider strong wind and earthquake.Please fasten the installation stand firmly with bolt or nails.Model A B C DE7*** 540 mm 160 mm 18.5 mm 330 mmE9***, E12***E15***613 mm 131 mm 16 mm 360.5 mmE18***, E21***E24***11.3.2 Connect the PipingConnecting the piping to indoorPlease make flare after inserting flare nut (locate atjoint portion of tube assembly) onto the copper pipe.(In case of using long piping)Connect the piping Align the center of piping and sufficiently tightenthe flare nut with fingers. Further tighten the flare nut with torque wrench inspecified torque as stated in the table.Connecting the piping to outdoorDecide piping length and then cut by using pipe cutter.Remove burrs from cut edge.Make flare after inserting the flare nut (locate at valve)onto the copper pipe.Align center of piping to valve and then tighten withtorque wrench to the specified torque as stated in thetable.11.3.3 Evacuation of the EquipmentWHEN INSTALLING AN AIR CONDITIONER, BE SURE TO EVACUATE THE AIR INSIDE THE INDOOR UNIT ANDPIPES in the following procedure.1 Connect a charging hose with a push pin to the Low side of a charging set and the service port of the 3-wayvalve.o Be sure to connect the end of the charging hose with the push pin to the service port.2 Connect the center hose of the charging set to a vacuum pump.3 Turn on the power switch of the vacuum pump and make sure that the needle in the gauge moves from0 cmHg (0 MPa) to -76 cmHg (-0.1 MPa). Then evacuate the air approximately ten minutes.Do not overtighten, overtightening may cause gas leakage.Piping size Torque6.35 mm (1/4”) [18 N•m (1.8 kgf.m)]9.52 mm (3/8”) [42 N•m (4.3 kgf.m)]12.7 mm (1/2”) [55 N•m (5.6 kgf.m)]15.88 mm (5/8”) [65 N•m (6.6 kgf.m)]19.05 mm (3/4”) [100 N•m (10.2 kgf.m)]