Panasonic CS-F24DB4E5 Service Manual

Also see for CS-F24DB4E5: Operating instructions Service manual Simplified service manual Operating instructions Service manual

Contents

Panasonic CS-F24DB4E5 Service Manual Manual pdf 74 page image

7410.6. Wired remote control installationWired Remote Control Installation Manual• Before installing the wired remote controller, be sure to thoroughly read the “Notes with regard to safety” section of theinstallation manual provided with the indoor unit.• After installing the wired remote controller, carry out a test operation to check that the remote controller functions properly, andalso explain the operation and cleaning procedures to the customer in accordance with the details in instruction manual.Furthermore, ask the customer to keep this installation manual and the instruction manual in a safe place for later reference.10.6.1. Accessories supplied with wired remote controller10.6.2. Notes regarding wired remote controller setting-up location• Select a place where the remote controler can be operated easily (after obtaining approval from the building’s owner).• Install in a place which is away from direct sunlight and as free from humidity as possible.• Install in a place which is as flat as possible to avoid warping of the remote controller.(If installed to a wall an uneven surface, damage to the LCD case or operation problems may result.)• Install in a place where the LCD can be seen easily. If the remote controller is installed somewhere which is too low or too high,it may be difficult to read the LCD. (Standard height from the floor is 1.2 to 1.5 meters.)• Avoid installing the remote control cable near refrigerant pipes or drain pipes.• Install the remote control cable at least 5cm away from other electric wires (including stereo and TV cables) to avoid mis-operation (electromagnetic noise).• If passing the remote control cable through a wall, be sure to install a water trap above the cable.• Allow sufficient space around the remote controller as shown in the illustration at right.Secure the remote controller lower case to the wall or to an outlet.10.6.3. Remote controller installation• Be sure to turn off the main power before installing and connecting the remote controller.(If the remote controller is connected while the power is still turned on, the remote controller displays may not appear.)If no displays appear on the remote controller, check while referring to “If no remote controller displays appear” in “5 Testoperation”.• The remote control cable is live during use, so please be careful with it.Name Q’ty Diagram RemarkRemote controller 1Remote control cable 1 Length (10m)4mm screw 3 Installing the remote controller to the wallM4 screw 3 Installing the remote controller to an outlet boxRound terminal 2 Connecting to indoor unit terminal block