Panasonic CS-KS12NB41 & CZ-18BT1U + CU-KS12NK1A Technical & Service Manual

Also see for CS-KS12NB41: Operating instructions

Contents

Panasonic CS-KS12NB41 & CZ-18BT1U + CU-KS12NK1A Technical & Service Manual Manual pdf 76 page image

6REMOTE CONTROLLERTransmitterWhen you press the buttons on the remote controller, the markappears in the display to transmit the setting changes to the receiverin the air conditioner.DisplayInformation on the operating conditions is displayed while the remotecontroller is switched on. If the unit is turned off, FLAP setting andFAN SPEED setting are not displayed.FAN SPEED selector button: The air conditioner automatically decides the fan speeds.: High fan speed: Medium fan speed: Low fan speedFLAP buttonPress this button either to select the setting of the airflow direction to the auto.flap in each mode or one of the six possible positions manually or to select thesweep function which moves the flap up and down automatically.: Auto flap setting: If selected in a cooling or dry operation, the flap is setat position (7) in the following chart.: The airflow direction can be set manually. (six positions): The flap moves up and down automatically.When you press the FLAP button, the air flow direction will be changed one byone as follows.NOTESWEEPCANCEL buttonSENSOR buttonWhen you press this button (use a small-tipped object such as a ballpointpen), the mark will appear at the display. And the room temperature isdetected by the sensor which is built into the indoor unit and the airconditioner is controlled accordingly.If the remote controller is located near a heat source, such as a spaceheater or in direct sunlight, press the SENSOR button to switch to thesensor on the indoor unit.NOTEADDRESS switch• The address switch changes to prevent mixing of signals from remote controller’s whentwo air conditioners are installed next to each other. Normally, the address switch is setto A. For more information, please contact the dealer where you made the purchase.• Normally, the tabs on the remote controller should not be bent.ON TIME/OFF TIME setting buttonsAdvance buttonReturn buttonNo display: The timer does not operate.: The air conditioner starts at the set time.: The air conditioner stops at the set time.: The air conditioner stops and starts, or starts andstops, at the set times every day. For details, see“SETTING THE TIMER”.HIGH POWER button: If this button is pressed during DRY, COOL or FAN operation, the unitoperates at maximum output for 30 minutes, regardless of thedesired temperature.The fan speed is 1step above ‘‘HIGH’’.Temperature display selector buttonThis switches the temperature displaybetween °C and °F.