12SPECIAL REMARKSHow it works?• Once the room temperature reaches the level that was set, theunit’s operation frequency is changed automatically.• During DRY operation, the fan speed automatically runs at lowerspeed for providing a comfortable breeze.• ‘‘DRY’’ operation is not possible if the indoor temperature is 59 °For less.• Sometimes the indoor unit may not get to the set fan speed such asLOW under cool operation at very low outdoor temperatures due tothe indoor unit being protected from ice or frost.• In the event of power failure, the unit will stop. When the power isresumed, the unit will restart automatically in approximately5 minutes by the remote controller.If the remote controller is on and left in a location where the unitcan receive a signal, then the unit will automatically restart inapproximately 5 minutes of power being restored.Clicking sound is heard from the air conditioner• In cooling operation, any plastic parts may shrink due to a suddentemperature change. In this event, a clicking sound may occur. Thisis normal, and the sound will soon disappear.• The remote controller sends the setting condition to the airconditioner regularly at five minute intervals.SETTING THE TIMERIn the descriptions below, the following settings are used for thetemperature and time indicator selector button on the bottom frontsection of the remote controller.• Temperature: °F• Time: AM, PM1. How to set the present time(Example) To set to 10:30 pm.‘‘DRY’’ ( ) OperationCooling ( ) operationPower failure during operationClicking SoundRemote ControllerOperation Indication1. Press the CLOCK buttononce if the time indicator isnot flashing.The time indication aloneflashes.2. Press the Advance, Return( , ) button until PM 10:30is displayed.The time can be set in 1-minuteincrements. Holding down thebutton advances the time rapidlyin 10-minute increments.3. Press the CLOCK buttonagain.This completes the setting of thecurrent time.NOTE