Panasonic CS-MKS9NB4U Technical & Service Manual

Also see for CS-KS18NB4UW & CZ-18BT1U + CU-KS18NKU: Technical & service manual Operating instructions Manual Specifications Installation instructions

Contents

Panasonic CS-MKS9NB4U Technical & Service Manual Manual pdf 49 page image

9OPERATION WITH THE REMOTE CONTROLLER1. Operation 2. Adjusting the Fan SpeedA. Automatic fan speedSimply set the FAN SPEED selector button to theposition.This automatically sets the best fan speed for the roomtemperature.B. Manual fan speedIf you want to adjust fan speed manually during operation,just set the FAN SPEED selector button as desired. [ ,, or ]3. Fan OnlyCheck that the circuit breaker on the power panel isturned on.Press the setting buttons as described below andchange the settings as desired.STEP 1 Press the MODE selector buttonand select the desired mode.For dehumidifying operationFor cooling operationFor fan only operationoooSTEP 2 To start the air conditioner, press the ON/OFF operation button.STEP 3 Press the TEMP. setting buttons to changethe temperature setting to the desiredtemperature.Adjustable temperature range:STEP 4 Set the FAN SPEED selector button to thesetting you want.STEP 5 Press the FLAP button and set the airflowdirection as desired.(Refer to “ADJUSTING THE AIRFLOWDIRECTION” on page 12.)To stop the air conditioner, press the ON/OFFoperation button again.• Choose the best position in the room for the remotecontroller, which also acts as the sensor for roomcomfort and transmits the operating instructions.Once you’ve found this best position, always keep theremote controller there.• This appliance has a built-in 5-minute time delaycircuit to ensure reliable operation. When theoperation button is pressed, the compressor will startrunning within three minutes. In the event of powerfailure, the unit will stop.STEP 2STEP 1STEP 3STEP 4STEP 5NOTE30 °C max.16 °C min.or 86 °F max.60 °F min.NOTEIf you want to circulate air without any temperaturecontrol, follow these steps:STEP 1 Press the MODE selector button to switch tothe fan mode .STEP 2 Press the ON/OFF operation button.STEP 3 Press the FAN SPEED selector button toselect the fan speed of your choice ( ,or ).STEP 2STEP 1STEP 3