Panasonic CS-PS9JKT Service Manual

Contents

Panasonic CS-PS9JKT Service Manual Manual pdf 26 page image

26Cover for thebottom pipingCover for thebottom pipingTapeit withpiping in a position asmentioned inFig. belowCover forthe rightpipingPipingDrainhoseCoverfor theleftpipingCover for pipingRight Rear pipingIn case of the cover is cut,keep the cover at the rear ofchassis as shown in theillustration for futurereinstallation.(Left, right and 2 bottomcovers for piping.)How to keep the coverRight and Right Bottom pipingCover for thebottom pipingTapeit with piping in aposition as mentionedinFig. belowCover forthe rightpipingPipingDrain hoseCoverforthe leftpipingInstall the indoor unitHook the indoor unit ontothe upper portion ofinstallation plate. (Engagethe indoor unit with theupper edge of theinstallation plate). Ensurethe hooks are properlyseated on the installationplate by moving it in leftand right.Drain hoseSleeveforpiping holeIndoor unitHooks atinstallationplatePipingInstallationplateSecure the Indoor UnitPress the lower left and rightside of the unit against theinstallation plate until hooksengages with their slot (soundclick).Unit’shookInsert the connecting cableTo take out the unit, push the marking at thebottom unit, and pull it slightly towards you todisengage the hooks from the unit.Guidesurface Connecting cableAbout7 – 8 cmConnectingcable Gas sidepipingLiquid sidepipingDrain hoseThis can be used for left rear piping and bottom piping also.Marking10.2.3 Indoor Unit Installation!Piping PipingIntake grilleShock absorber• Use shock absorber during pull outthe piping to protect the intake grillefrom damage.Do not turn over the unit without it ’s shockabsorber during pull out the piping. It maycause intake grille damageCaution!10.2.3.1 For the right rear piping10.2.3.2 For the right and right bottom pipingPull out the Indoor PipingInstall the Indoor UnitSecure the Indoor UnitInsert the power supply cable and connecting cable Insert the cables from bottom of the unit throughthe control board hole until terminal board area.Pull out the Indoor PipingInstall the Indoor UnitInsert the power supply cable and connecting cableSecure the indoor unitInsert the cables from bottom of the unit throughthe control board hole until terminal board area.