ENGLISH9Information for Users on Collection and Disposal of Old Equipment and used Batteries[Information on Disposal in other Countriesoutside the European Union]These symbols are only valid in the EuropeanUnion. If you wish to discard these items,please contact your local authorities or dealerand ask for the correct method of disposal.Note for the battery symbol (bottom twosymbol examples):This symbol might be used in combination witha chemical symbol. In this case it complies withthe requirement set by the Directive for thechemical involved.PbContact your local hazardous waste disposal hotline.FOR SEASONAL INSPECTION AFTER EXTENDEDNON-USE• Check remote control batteries.• No obstruction at air inlet and air outlet vents.• Use Auto OFF/ON button to select Cooling operation.After 15 minutes of operation, it is normal to have thefollowing temperature difference between air inlet and airoutlet vents:Cooling: ≥ 14.4°FFOR EXTENDED NON-USE• Switch off power at the circuit breaker.• Remove the remote control batteries.SERVICEABLE CRITERIASSWITCH OFF POWER AT THE CIRCUIT BREAKER thenplease consult an authorized dealer under the followingconditions:• Abnormal noise during operation.• Water/foreign particles have entered the remote control.• Water leaks from Indoor unit.• Circuit breaker switches off frequently.• Switches or buttons are not functioning properly.INFORMATIONModel Number CS-S9NKUW-1 / CU-S9NKU-1The above listed models have been designed and manufactured to meet ENERGY STAR® criteria forenergy efficiency when matched with appropriate coil components. However, proper refrigerant chargeand proper air flow are critical to achieve rated capacity and efficiency. Installation of this product shouldfollow the manufacturer’s refrigerant charging and airflow instructions. Failure to confirm proper chargeand airflow may reduce energy efficiency and shorten equipment life.Federal Communications Commission Interference StatementThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) this device must accept any interference received, including interference that maycause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 ofthe FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications. However, there is no guaranteethat interference will not occur in a particular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.FCC Caution: To assure continued compliance, follow the attached installation instructions. Any changes or modifications notexpressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.Industry Canada NoticeThis Class B digital apparatus complies with Canadian ICES-003.