9314.4.2 Horizontal Airflow (CS-TZ24SKEW)1 Automatic horizontal airflow direction can be set using remote control; the vane swings left and right withinthe angles as stated below. It does not swing during fan motor stop. For heating mode operation, the angle ofthe vane depends on the indoor heat exchanger temperature as Figure 1 below.Operation Mode Vane Angle (°)Heating, with heat exchanger temperature A 60 ~120B 90Cooling and soft dry 60 ~12043°C40°C0° Top View23145B: fix frontA: swingIndoor Heat ExchangerTemperatureFigure 1 Figure 22 Manual horizontal airflow direction can be set using remote control; the angles of the vane are as statedbelow and the positions of the vane are as Figure 2 above.Pattern 1 2 3 4 5Airflow DirectionPatterns at RemoteControlVane Angle (°) 90 60 75 105 12014.5 Timer Control There are 2 sets of ON and OFF timer available to turn the unit ON or OFF at different preset time. If more than one timer had been set, the upcoming timer will be displayed and will activate in sequence.14.5.1 ON Timer Control ON timer 1 and ON timer 2 can be set using remote control, the unit with timer set will start operate earlier thanthe setting time.This is to provide a comfortable environment when reaching the set ON time. 60 minutes before the set time, indoor (at fan speed of Lo-) and outdoor fan motor start operate for 30 seconds todetermine the indoor intake air temperature and outdoor air temperature in order to judge the operation startingtime. From the above judgment, the decided operation will start operate earlier than the set time as shown below.Indoor intake airtemperature (o C)Outdoor airtemperature (o C)3030 35Cooling/Soft Dry(o C)10 min15 min5 min25Indoor intake airtemperature (o C)Outdoor airtemperature (o C)150 5Heating(oC)30 min25 min35 min514.5.2 OFF Timer ControlOFF timer 1 and OFF timer 2 can be set using remote control, the unit with timer set will stop operate at set time.