Panasonic CS-V12CTP Operating Instructions Manual

Also see for CS-A12CTP: Brochure Operating instructions Operating instructions Service manual Technical information

Contents

Panasonic CS-V12CTP Operating Instructions Manual Manual pdf 5 page image

4NAME OF EACH PART Remote Control Remote Control Signal.• Make sure it is not obstructed.• Maximum distance : 10 m.• Signal received sound.One short beep or one long beep. Notes for Remote Control.• Do not throw or drop.• Do not get it wet.• Certain type of fluorescent lamps may affectsignal reception. Consult your dealer. Do not place the remote control in a location exposedto direct sunlight, or next to a heating unit, or otherheat source. How to Insert the Batteries1 Gently press the place marked OPEN and slidethe cover towards you.2 Insert the batteries– Be sure the direction is correct. About the batteries• Can be used for approximately one year. Observe the following when replacing the batteries• Replace with new batteries of the same type.• Do not use rechargeable batteries (Ni-Cd).• Remove the batteries if the unit is not going to beused for a long period. Proper way to operate the remote control in thecase of ceiling/wall mounting.• Operate the remote control in parallel with the floor.(See the figure below)1 Signal Transmitter2 Operation Display3 Room Temperature Setting Button(Illuminating button)4 Operation Mode Selection Button5 Sleep Mode Operation Button(Illuminating button)6 Timer Setting Button7 Timer Selection Button8 OFF/ON Button(Illuminating button)9 Fan Speed Selection Button0 Auto Airflow Direction Button! Timer Set/Cancel Button@ Manual Airflow Direction Selection Button# Reset Point(Press with fine-tipped object to clear the memory)1.5V1.5VOPEN12AUTAUTOHEAHEATCOOLCOOLDRDRYFANSPEEDHHOFF OFF ONONA BAUTOCOOLCOOLDRYFANFANANSPEEDSPEEDHHOFFOFF OFFOFF ONONONONA BCooling ModelHeat Pump Model"!#$35768941OFF/ONTEMPMODE SLEEP FAN SPEEDAUTOMANUALTIMER AIR SWINGSELECT SET/CANCELRESETA BAUTAUTOHEAHEATCOOLCOOLDRDRYFANANSPEEDSPEEDHHOFFOFF OFFOFF ONONONONA B2• The signal changes as shown in the figure below.It means that the receiving conditions are bad andthe signal can not be controlled properly.O.K.OUT(Fig. 2)(Fig. 1) Horizontal Level