Panasonic CT-26WC15 Operating Instructions Manual

Contents

I NSTALLATION5 zENGLISHInstallationTelevision LocationThis unit can be used as part of an entertainment center. Consultyour dealer for available options.• Avoid excessive sunlight or bright lights, includingreflections.• Keep away from excessive heat or moisture. Inadequateventilation may cause internal component failure.• Fluorescent lighting may reduce remote controltransmitting range.• Keep away from magnetic equipment, including motors,fans and external speakers.WARNING: Use this television receiver only with thecart, stand, tripod, bracket, or table specified by themanufacturer, or sold with the apparatus. When a cartis used, use caution when moving the cart/apparatuscombination to avoid injury from tip-over. In order toavoid injury to children, never place your television receiver on apiece of furniture that is capable of being tilted by a child leaningon it, pulling on it, standing on it, or climbing on it. A fallingtelevision can cause serious injury or even death.CT-34WC15, CT-34WC15U:CAUTION: This television receiver for use only withPANASONIC TY-34WX15T stand. Use with other carts(or stands) is capable of resulting in instability causingpossible injury.CT-34WX15, CT-34WX15U:CAUTION: This television receiver for use only withPANASONIC TY-34WX15T stand. Use with other carts(or stands) is capable of resulting in instability causingpossible injury.Optional Cable ConnectionsShielded audio and video cables should be used betweencomponents. For best results:• Use 75-ohm coaxial shielded cables.• Use appropriate input and output connectors that matchyour component connectors.• Avoid long cables to minimize interference.AC Power Supply CordCAUTION: TO PREVENT ELECTRIC SHOCK,MATCH WIDE BLADE OF PLUG TO WIDE SLOTOF AC OUTLET AND FULLY INSERT. DO NOTUSE A PLUG WITH A RECEPTACLE OR OTHEROUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TOPREVENT BLADE EXPOSURE.PROTECT POWER CORDS FROM BEING WALKED ON, ROLLEDOVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXITFROM THE APPARATUS.Cable / Antenna ConnectionFor proper reception, either a cable or antenna connectionis required.Cable ConnectionConnect the cable supplied by your localcable company. Tighten with fingers only.Use of any tool (e.g. pliers) for tighteningmay result in tuner damage.Note: A cable converter box may berequired for proper reception.Check with your local cablecompany for compatibility requirements.Antenna ConnectionFor proper reception of VHF/UHF channels, an external antennais required. For best reception an outdoor antenna isrecommended.• Connect home antenna to ANTconnection on back of television.Note: Cable Mode is preset at thefactory. Antenna mode can beselected in the Set Up sub-menu.Remote Control Battery InstallationRequires two AA batteries (supplied) .Procedure1. Turn the remote control face down. Remove batterycover by pressing down on the marking on the coverand sliding it off in the direction indicated.2. Install batteries matching (+) and (-) polarity signs.3. Replace the battery cover by sliding it in reverse untilthe lock snaps.Note: Incorrect installation can cause battery leakage andcorrosion that will damage the Remote Control.Precautions• Replace batteries in pairs.• Do not mix battery types (zinc carbon with alkaline).• Do not recharge, heat, short-circuit, disassemble, orburn batteries.Polarized plug75 Ohm VHF/UHFon back of TVIncoming Cable fromCable CompanyIncoming Cable fromHome Antenna1AA / 1.5AAA / 1.5ABattery Polarity2AA / 1.5AAA / 1.5A3