Panasonic CU-PW9DKE Service Manual

Panasonic CU-PW9DKE Service Manual Manual pdf 31 page image

SELECT THE BEST LOCATIONINDOOR UNITııııııOUTDOOR UNITIndoor/Outdoor Unit Installation Diagram- 31 -CS-PW9DKE / CU-PW9DKE / CS-PW12DKE / CU-PW12DKEAttached accessories.1No. Accessories part Qty. No. Accessories part Qty.1234Installation plateInstallation plate fixingscrewRemote controlBattery15125Drain elbow16Connecting Wire (Connector)Indoor/Outdoor Unit Installation DiagramAbout 1.1 mPiping direction Attention not tobend up drain hoseLength of power supply cordRightRight BottomRight RearLeftRear Left BottomLeft(Front side)About 1.8 m<< <<There should not be any obstacles blocking the aircirculation.A place where air circulation in the room is good.A place where drainage can be easily done.A place where noise prevention is taken intoconsideration.Do not install the unit near the door way.Ensure the spaces indicated by arrows from the wall,ceiling, fence or other obstacles.Recommended installation height for indoor unit shallbe at least 2.5 m.ıThere should not be any heat source or steam nearthe unit.If an awning is built over the unit to prevent directsunlight or rain, be careful that heat radiation from thecondenser is not obstructed.There should not be any animal or plant which couldbe affected by hot air discharged.Keep the spaces indicated by arrows from wall,ceiling, fence or other obstacles.Do not place any obstacles which may cause a shortcircuit of the discharged air.If piping length is over the common length, additionalrefrigerant should be added as shown in the table.ModelPW9DKEPW12DKEPiping size Max. PipingLength(m)1015CommonLength(m)7.57.5Max.Elevation(m)55AdditionalRefrigerant(g/m)2020Gas3/8"3/8"Liquid1/4"1/4"This illustration is for explanation purposes only.The indoor unit will actually face a different way.Installation plate 1Sleeve ( )Bushing Sleeve ( )Putty (Gum type sealer) ( )Vinyl tape (Wide) ( )Apply after carrying out adrainage test.To carry out the drainagetest, remove the air filtersand pour water into the heatexchanger.Saddle ( )5-CORE WIRE/1.5 mm2Type designation 245 IEC 57or heavier cordAdditional drain hose ( )Bend the pipe as closely onthe wall as possible, but becareful that it doesn t break.Installation parts youshould purchase ( )Gas side piping ( ) 3/8"1/4" Liquid side piping ( )10 cmor more10 cmor more100 cmor moreConnecting cable5 cmor more5 cmor more30 cmor more(Left and right are identical)Insulation of piping connectionsCarry out insulationafter checking forgas leaks andsecure with vinyltape.Vinyl tape