Panasonic CU-RE24HKE Operating Instructions Manual

Also see for CS-RE18HKE: Operating instructions

Contents

6RemoveRemoveRemoveRemoveCARE & CLEANINGCARE & CLEANING• Switch off the power supply before cleaning.• Do not touch the aluminium fin, sharp parts may cause injury.WASHING INSTRUCTIONSWASHING INSTRUCTIONS• Do not use benzene, thinner or scouring powder.• Use only soap ( pH7) or neutral household detergent.• Do not use water hotter than 40°C.HINTSHINTS• Clean the filter regularly for best performance and toreduce power consumption.• Please consult your nearest dealer for seasonalinspection.CAUTIONINDOOR UNITINDOOR UNITWipe the unit gently with a soft, dry cloth.ALUMINIUM FINALUMINIUM FINRaise and pull to remove. Wash gently and dry.FRONT PANELFRONT PANELAIR FILTERSAIR FILTERS• Air filters cleaning is needed every two weeks.• Wash/rinse the filters gently with water to avoid damageto the filter surface.• Dry the filters thoroughly under the shade, away from fireor direct sunlight.• Replace any damage filter.• Vacuum the filter whenever necessary.• Replace the filter every 10 years or replace anydamaged filter.Part no.: CZ-SA16PSUPER ALLERU-BUSTER FILTERSUPER ALLERU-BUSTER FILTERVacuum the superalleru-buster filter.FOR SEASONAL INSPECTION AFTER EXTENDEDFOR SEASONAL INSPECTION AFTER EXTENDEDNON-USENON-USE• Checking of remote control batteries.• No obstruction at air inlet and air outlet vents.• After 15 minutes of operation, it is normal to have the followingtemperature difference between air inlet and air outlet vents:Cooling: ≥ 8°C Heating: ≥ 14°CNON SERVICEABLE CRITERIASNON SERVICEABLE CRITERIASTURN OFF POWER SUPPLY then CALL AuthorizedDistributor under the following conditions:• Abnormal noise during operation.• Water/foreign particles have entered the remote control.• Water leaks from Indoor unit.• Circuit breaker switches off frequently.• Power cord becomes unnaturally warm.• Switches or buttons are not functioning properly.FOR EXTENDED NON-USEFOR EXTENDED NON-USE• Activate Heat mode for 2~3 hours to remove moisture left inthe internal parts thoroughly.• Turn off the power supply.• Remove the remote control batteries.