Panasonic CU-UE12ZKF-3 Operating Instructions Manual

OPERATING INSTRUCTIONAny attempt to use this unit under temperature conditions beyond the specified range may cause the airconditioner protection device to start and unit may fail to operate. Therefore, ensure to use the air conditionerwithin the specified limits as mentioned below:In case of power cut when the units restarts after supply is restored or if the user switch the mode of operationfrom one mode to another, the compressor protection device is activated. In this case compressor resumesoperation after 3 minutes.Characteristics of heating operation (applicable to heat pump models)Pre-heating:When heating function is activated, the indoor unit takes 2-5 minutes for preheating, after that the unit willstart heating and blow warm air.Defrosting:During heating function frost is slowly accumulated on outdoor unit, under this situation the unit will switchto defrost mode automatically to improve heating effect. During defrost cycle indoor and outdoor fan will stoprunning. Unit will resume heating once defrosts cycle is completed.Emergency button:Open the panel and find the emergency button on the control box. Use this button when remote control fails tooperate. (Always press emergency button with insulated material).Current Status Operation Response Enter ModeStand by Press emergencybutton once Beeps once CoolingStand by (For heatpumps)Press emergencybutton twice in 3 sec Beeps twice HeatingRunning Press emergencybutton once Beeps for a while OFF14