Panasonic CY-TUN153U Operating Instructions Manual

Also see for CY-TUN153U: Service manual

Contents

12 EnglishCY-TUN153U 13 EnglishCY-TUN153URecommended System and Operation11 12Diversity TV AntennaTo use the two TV antennaeprovided Plug the four terminals for the two antennae into thetuner. Combine the tuner TV terminals and the antennaterminals as shown on page 26. Make sure the DIVER (Diversity) setting is “ON”.To use the two optional antennaeTwo antennae must be prepared. Plug the four terminals for the two antennae into thetuner. Combine the tuner TV terminals and the antennaterminals as shown on page 26.How to plug the antennae in when there is only oneantenna terminal.Diversity TV Antenna:Of the two antennae connected to the system, the onewith the best reception is automatically selected for TVreception. Turning DIVER (Diversity) setting to “ON”reduces noise.To make effective use of this diversity function: Connect both two TV antennae provided. Turn DIVER (Diversity) setting to “ON”.Note: If only one is connected, the diversity function hasno effect.Note:If there is no alternative but to use only one optional TVantenna, the diversity function has no effect.1. The way to plug the antennae varies with the numberof antenna terminals.How to plug the antennae in when there is only oneantenna terminal.How to plug the antennae in when there are twoterminals. Make sure the DIVER (Diversity) setting is “ON”.2. Make sure the DIVER (Diversity) setting is “OFF”.Expansion Module Connection(Connection is possible even without an ExpansionModule Connection.) TV tunerWe recommend using this TV tuner with the Panasonic Head Unit below.For details on the head unit and head unit remote control operations, refer to the operating instructions for the Head Unit.Head Unit with Touch Panel Control (CQ-VD7003U, CQ-VD6503U),Expansion Module (CY-EM100U) and TV TunerUse the Head Unit touch panel to operate the TV tuner.For details on the touch panel and remote control operations, refer to the chapter on TV operations in the operatinginstructions for the Head Unit.TV tuner remote control unit:Use this remote control unitfor TV tuner setup operations(DIVER (Diversity) AntennaSetting).Head Unit remote control unit:This remote control unit enables you toadjust the volume, switch sources, changeTV channels, and confi gure the auto presetmemory setting.Combination of this TV tuner with the non-PanasonicHead Unit (in-car audio system with a monitor/AV unit):It will not be possible to operate this TV tuner with aremote control unit, or that of the non-Panasonic HeadUnit.For connection confi gurations other than therecommended connection confi gurations above, refer tothe following pages. Head Unit (CQ-VD7001U): Page 30 Rear Monitor (CY-VHD9401U): Page 31The remote control units supplied with the Head Unit andRear Monitor cannot be used for TV tuner operations.(Except for adjusting the volume, switching sources, etc.)DIVER (Diversity)Antenna SettingConfi rm “ON” to receive a good reception.Default: ONSetting: ON/OFF Press [PWR] (Power). Press [MENU]. Press [] or [] to select “ON” or “OFF”. Press [ENT] (ENTER) or [MENU] to set and return tothe previous display.