Basic Functions of theCZ-RTC2Remote Controller1. Start/Stop Button:Pushing this button starts and pushing again stops the unit.2. Operation Lamp:This lamp is turned on when the air conditioner is in operation. This lamp blinkswhen an error occurs or a protective device has activated.Operation lamp Start / Stop Button3. Mode select button:Push this button to select an operation mode .Each time the Mode Select Button ispressed it cycles through all the available modes. In this example the mode is set toAuto. (If applicable to your system).Auto Mode: Automatically sets the system to heating or cooling for single splitsystems (Heat P ump models only).Auto Mode IconMode select Button

Panasonic CZ-RTC2 User Functions Manual

important safety instructions

names and operations

wichtige sicherheitshinweise

bezeichnungen und funktionen

ajuste de la hora actual

CZ-RTC2

Display

Names and operations

Deleting/invalidating program timer

Duplicating the program timer

Outing function

Sleeping function

Installation

Meaning of alarm messages

remote controller