7. Adjusting the Wind DirectionEN-11ENPlease face the fl ap (up-down winddirection plate) downwards. If it facesupwards, the warm air will not reachthe fl oor level.In the Heat ModePlease face the fl ap (up-down winddirection plate) upwards. If the platefaces downwards, condensationmay form and drip from around theair outlet. In the Cool and Dry ModesIn the Fan Mode In All ModesDisplays with Swing StoppedInitial SettingInitial SettingInitial Setting Moves ConstantlyFan/Heat Modes Cool/Dry Modes• Never try to manually move the fl ap (up-down wind direction plate) that is operated by the remotecontrol.• When the unit stops, the fl ap (up-down wind direction plate) automatically faces downwards.• When the unit is in heating standby, the fl ap (up-down wind direction plate) faces upward. Also,bear in mind that the fl ap starts swinging after the heating standby mode is released, but thedisplay on the remote control indicates Auto Flap during standby heating as well.CZ-RWSU2/CZ-RWST2/CZ-RWSL2/CZ-RWSY2/Indoor Unit (CZ-RWSK2)Setting the Wind DirectionWhile the unit is operating, every time you press , thedirection the fl ap faces changes.Setting Flap to SwingIf you press to set the fl ap (up-down wind directionplate) in its most downward facing position, and thenpress again, is displayed and the fl ap swingsautomatically up and down.Stopping Flap SwingIf you press again while the fl ap is swinging, you canstop the fl ap from swinging and set it in place as desired.Thereafter, if you press , you can set the wind directionstarting from the most upward position.• When the unit is in the Cool or Dry modes, the fl ap cannotstop facing downwards. If you try to stop the fl ap fromswinging while it is facing downwards, it will continuemoving until it is in the third position from the top.