Panasonic CZ-RWSU3 Operating Instructions Manual

Also see for CZ-RWSC3: Installation instructions Quick reference Operating instructions Quick reference Operating instructions

Contents

Panasonic CZ-RWSU3 Operating Instructions Manual Manual pdf 16 page image

7. Adjusting the Wind Direction16 (EN)• Never try to manually move the flap (up-down wind direction plate) that isoperated by the remote controller.• When the unit stops, the flap (up-down wind direction plate) automaticallyfaces downwards.• When the unit is in heating standby, the flap (up-down wind direction plate)faces upwards. Also, bear in mind that the flap starts swinging after theheating standby mode is released, but the display on the remote controllerindicates Auto Flap during standby heating as well.CZ-RWSU3/CZ-RWSU2N/CZ-RWSD2/CZ-RWSL2N/For wall mounted type indoor unit(CZ-RWSK2)/CZ-RWST3NSetting the Wind DirectionWhile the unit is operating, every timeyou press , the direction the flapfaces changes.Setting Flap to SwingIf you press to set the flap (up-down wind direction plate) in its mostdownward facing position, and thenpress again, is displayedand the flap swings automatically upand down.Stopping Flap SwingIf you press again while the flapis swinging, you can stop the flap fromswinging and set it in place asdesired. Thereafter, if you press ,you can set the wind direction startingfrom the most upward position.• When the unit is in the Cool or Drymode, the flap cannot stop facingdownwards. If you try to stop theflap from swinging while it is facingdownwards, it will continue movinguntil it is in the third position fromthe top.In the Heat ModePlease face the flap(up-down winddirection plate)downwards. If it facesupwards, the warm airwill not reach the floor level.In the Cool or Dry ModePlease face the flap(up-down winddirection plate)upwards. If the platefaces downwards,condensation mayform and drip fromaround the air outlet.In the Fan ModeInitial settingIn All ModesMoves constantlyDisplays with Swing StoppedFan/HeatmodesCool/DrymodesInitial settingInitial setting