Panasonic CZRWSU2N Operating Instructions Manual

Also see for CZ-RWSC3: Installation instructions Quick reference Operating instructions Quick reference Operating instructions

Panasonic CZRWSU2N Operating Instructions Manual Manual pdf 18 page image

9. Using the Remote Controller18 (EN)• Point the transmitter of the remote controller at the receiver. When thesignal is received properly, it will beep one time. (It only beeps two timeswhen the unit starts operating.)• The signal can be received at a distance of up to about 6 meters. Thisdistance should be used only as a guide. It depends on battery strength.• Make sure nothing is between the remote controller and the receiver thatcould block the signal.• Do not leave the remote controller in direct sunlight, where the wind fromthe air conditioner can blow directly on it, or near any other heat source.• Take care not to drop, throw, or wash the remote controller with water.• The signal from the remote controller may not be received in rooms withrapid start fluorescent lighting, inverter lights, plasma displays, LCDtelevisions (monitor), etc. For more information, please contact thedistributor where the product was purchased.Wall Mount Use• Press from the locationyou wish to mount the remotecontroller and make sure thesignal is received properly.• Pull the remote controllerforward to remove it.10. For Best ResultsDon’t get the remote controller too far away from the receiver.This may cause a malfunction.Be sure to keep the remote controller in the same room as the receiver.Point the remote controller at the receiver.When the signal is received properly, it will beep one time.Avoid locating the remote controller where it is covered, such asbehind a curtain.Keep it out in the open.Remote controlholderFasten the remotecontrol holder withscrews.Fitting the remotecontroller in theholderPushFit in