Panasonic DMP-BD70V Operating Instructions Manual

Also see for DMP-BD70V - Blu-ray Disc/VHS Multimedia Player: Specifications

Panasonic DMP-BD70V Operating Instructions Manual Manual pdf 38 page image

RQT941238MessagesThe following messages or service numbers appear on the television or unit’s display when something unusual is detected during startup and use.On the television PageCannot play. ≥You inserted an incompatible disc (Discs recorded in PAL video, etc.). 6, 7Cannot display on this unit. ≥You tried to play a non-compatible image.≥Confirm “SD” on the unit’s display is not blinking and re-insert the card.7, 37—No disc is inserted. ≥The disc may be upside down. —$ This operation is notavailable.≥Some operations are unsupported by the unit. For example;– [BD-V]: During playback, reverse slow-motion or reverse frame-by-frame is not possible.20$ This operation isprohibited by this disc.≥Depending on the disc, you may not be able to perform search or skip when filmpreviews and warning screens are being played back.20Cannot connect.Please check theconnection of the LANcable.≥When a hub is used but its Link lamp does not light up, check the cableconnection, LAN terminal connection, cable itself (a cross over cable may beused by mistake), etc.16IP address is not set. ≥The “IP Address” in “IP Address/DNS Settings” is “---. ---. ---. ---”. Set the “IPAddress”, “Subnet Mask”, and “Default Gateway”. (Select the automatic addressacquisition if necessary.)17Cannot obtain IP addressusing DHCP.Please check theconnection or routersettings.≥If you use a hub, then check the connection between the hub and the router.–Use the UPLINK port of the hub to connect to a router.–Check whether or not the hub’s Link lamp lights up. If it does not light up, thencheck the cable connection, LAN terminal connection, cable itself (a cross overcable may be used by mistake), etc.≥If the above conditions are OK, then the router may not operate in DHCP mode.Check the router settings and operation. You may reset the router to restore it tonormal.1616This IP address is already inuse.Please check the IP addresssetting.≥This unit’s IP address is used by another device. Check the IP addresses of thisunit, personal computers, and routers, etc. If necessary, reconfigure them toavoid IP addresses from being duplicated.—Unable to performConnection Test.Please try again.≥Turn the unit off. Remove the power cord and reconnect it and try again. If thesame symptom persists, then consult your dealer.—IP address not set correctly.Connection Test wasunsuccessful. No replyfrom host.Please check theconnection or routersettings.≥If you use a hub, then check the connection between the hub and the router.–Use the UPLINK port of the hub to connect to a router.–If the hub’s Link lamp does not light up, then check the cable connection, LANterminal connection, cable itself (a cross over cable may have been used bymistake), etc.≥Check the “IP Address”, “Subnet Mask”, and “Default Gateway” in the “IPAddress/DNS Settings”.≥If the MAC address information is required, then press [SETUP] to display the“Network” menu.161717, 35Network connectionrefused.Please confirm Setup“BD-Live Internet Access.”≥When you set “BD-Live Internet Access” to “Allow (Limited)” and play BD-Livecontents which do not have a content owner certificate, the Internet access of thecontent is not allowed. If you allow the content to connect to Internet, set “BD-LiveInternet Access” to “Allow (ALL)”.32Unable to check for latestfirmware version.Please try again later.≥The firmware download server is currently unavailable. Please try again later. —