Panasonic DMP-BD80 Operating Instructions Manual

Also see for DMP-BD60 - Blu-Ray Disc Player: Operating instructions Operating instructions Specifications Operating instructions Service manual

Panasonic DMP-BD80 Operating Instructions Manual Manual pdf 14 page image

14RQT9401Network settingsThese settings are used if you will connect this unit to the Internet.≥The connection to the Internet may take time or the Internet may not be connected depending on the connection environment. (> 32)It is required that you use a broadband connection.Preparation≥Connect to the network. (> 13)Testing of “IP Address / DNS Settings”Always test the connection when a LAN cable is connected.1 Press [SETUP].2 Press [3, 4] to select “Network Settings”and press [OK].3 Press [3, 4] to select “IP Address / DNSSettings” and press [OK].4 Press [3, 4] to select “Connection Test” andpress [OK].“Testing...”:The test is in progress.“Pass”: The connection is completed.Press [RETURN] to exit.“Fail”: Please check the connection and settings.[Note]≥Perform the “Connection Test” also when any change was madeto the “IP Address / DNS Settings”.≥If the connection test fails, it may be necessary to set the MACaddress of this unit at the router side. The MAC address can bedisplayed by pressing [SETUP] and selecting “Network Settings”.NRUTERKOIP Address / DNS SettingsConnection TestOnOnOnOnOnOnIP Address Auto-AssignmentIP AddressSubnet MaskGateway AddressDNS-IP Auto-AssignmentPrimary DNSSecondary DNSConnection Speed Auto-ConfigConnection Speed SettingRETURNNetwork SettingsIP Address / DNS SettingsProxy Server SettingsMAC Address: xx-xx-xx-xx-xx-xxOKNetwork ServiceSetting the IP addressIn most cases, default settings can normally be used withoutmaking any changes.Set the IP address only when the router has no DHCP serverfunctions or when the router’s DHCP server function isdisabled.After performing steps 1–3 (D left)4 Press [3, 4] to select “IP AddressAuto-Assignment” and press [2, 1] to select“Off”.5 Press [3, 4] to select “IP Address”, “SubnetMask” or “Gateway Address” and press [OK].6 Enter numbers with the numbered buttonsand press [OK].≥After checking the specifications for your broadband router,enter each number.If the number is unknown, then check the number of otherdevices such as personal computers connected via a LANcable. Assign a different number from those of other devicesfor the “IP Address” and the same number for others.≥If a wrong number is entered, then press [CANCEL].7 Press [2, 1] to select “Yes” and press [OK].[Note]≥The numeric input range is between 0 and 255.Setting the DNS-IPIn most cases, default settings can normally be used withoutmaking any changes.When setting an assigned DNS server from your Internetservice provider, perform the following settings.After performing steps 1–3 (D left)4 Press [3, 4] to select “DNS-IPAuto-Assignment” and press [2, 1] to select“Off”.5 Press [3, 4] to select “Primary DNS” or“Secondary DNS”and press [OK].6 Enter numbers with the numbered buttonsand press [OK].≥Follow the instructions given by your Internet serviceprovider and enter the numbers.If the number is unknown, then check the number of otherdevices such as personal computers connected via a LANcable and assign the same number.≥If a wrong number is entered, then press [CANCEL].7 Press [2, 1] to select “Yes” and press [OK].[Note]≥The numeric input range is between 0 and 255.192 . . .1Primary DNSPlease input Primary DNS and press[OK]. Press [CANCEL] to delete the selectedcharacter. To clear this setting, delete allcharacters and press [OK].Number0 - 9