Reference37VQT3V64MessagesThe following messages or service numbers mayappear on the TV or unit’s display.Cannot play.Cannot play on this unit.¾ You tried to play a non-compatible image.¾ Confirm “SD” on the unit’s display is notdisplayed and re-insert the card.No disc inserted.¾ The disc may be upside down.$ This operation is not available.¾ Some operations are unsupported by the unit.For example;IP address is not set.¾ The “IP Address” in “IP Address / DNSSettings” is “---. ---. ---. ---”. Set the “IPAddress”, “Subnet Mask”, and “GatewayAddress”. (Select the automatic addressacquisition if necessary.)The wireless access point currently has a lownetwork security setting. It is recommended tochange to a higher setting.¾ Authentication type for the wireless LAN is setto “Open system”, or the encryption type isset to “No encryption”. It is recommended toencrypt for safety reasons. For details, referto the instructions of the wireless router beingused. Encryption is required when playingback video, etc., from DLNA compatibledevices.F99¾ The unit fails to operate properly. Press [Í/I]on the main unit for 3 seconds to switch theunit to standby, then switch back on.HDMI ONLY¾ Some BD-Video discs can only be output withHDMI.NET¾ While connecting to a network.No PLAY¾ There is a viewing restriction on a BD-Videoor DVD-Video. (> 31)No READ¾ The media is dirty or badly scratched. Theunit cannot play.PLEASE WAIT¾ The unit is carrying out internal process. Thisis not a malfunction. You cannot operate theunit while “PLEASE WAIT” is displayed.REMOVE¾ The USB device is drawing too much power.Remove the USB device.SET (“ ” stands for a number.)¾ The remote control and main unit are usingdifferent codes. Change the code on theremote control.U59¾ The unit is hot.The unit switches to standby for safetyreasons. Wait for about 30 minutes until themessage disappears.Select a position with good ventilation wheninstalling the unit.On the television¾ You inserted an incompatible disc.– BD-Video: During playback, reverseslow-motion or reverse frame-by-frame isnot possible.On the unit’s displayPress and hold [OK] andthe indicated numberbutton at the same timefor more than 5 seconds.