Panasonic DMP-BDT220 Owner's Manual

Also see for DMP-BDT220: Operating instructions Operating instructions Operating instructions

Panasonic DMP-BDT220 Owner's Manual Manual pdf 34 page image

34 VQT3V20MessagesThe following messages or service numbersappear on the television or unit’s display.Cannot play.¾ You inserted an incompatible disc (Discsrecorded in PAL video, etc.).Cannot display on this unit.¾ You tried to play a non-compatible image.¾ Confirm “SD” on the unit’s display is notdisplayed and re-insert the card.No disc inserted.¾ The disc may be upside down.$ This operation is not available.¾ Some operations are unsupported by the unit.For example;– BD-Video: During playback, reverseslow-motion or reverse frame-by-frame isnot possible.IP address is not set.¾ The “IP Address” in “IP Address/DNSSettings” is “---. ---. ---. ---”. Set the “IPAddress”, “Subnet Mask”, and “DefaultGateway”. (Select the automatic addressacquisition if necessary.)The current wireless network security settingis weak. It is recommended to change to astronger security setting.¾ Authentication type for the wireless LAN is setto “Open system”, or the encryption type isset to “No encryption”. It is recommended toencrypt for safety reasons. For details, referto the instructions of the wireless router beingused. Encryption is required when playingback video, etc., from DLNA compatibledevices.F99¾ The unit fails to operate properly. Press [Í/I]on the main unit for 3 seconds to switch theunit to standby, then switch back on.HDMI ONLY¾ Some BD-Video discs can only be output withHDMI.NET¾ While connecting to a network.No PLAY¾ There is a viewing restriction on a BD-Videoor DVD-Video. (> 29)No READ¾ The media is dirty or badly scratched. Theunit cannot play.PLEASE WAIT¾ The unit is carrying out an internal process.This is not a malfunction. You cannot operatethe unit while “PLEASE WAIT” is displayed.REMOVE¾ The USB device is drawing too much power.Remove the USB device.SET (“ ” stands for a number.)¾ The remote control and main unit are usingdifferent codes. Change the code on theremote control.Press and hold [OK] and theindicated number button atthe same time for more than5 seconds.On the televisionOn the unit’s display