Panasonic DMP-BDT310 Operating Instructions Manual

Also see for DMP-BDT110: Owner's manual Owner's manual Operating instructions Operating instructions Owner's manual

Reference39VQT3B77MessagesThe following messages or service numbers appear on thetelevision or unit’s display when something unusual isdetected during startup and use.Cannot play.¾ You inserted an incompatible disc.Cannot play on this unit.¾ You tried to play a non-compatible image.¾ Confirm “SD” on the unit’s display is not displayed andre-insert the card.No disc is inserted.¾ The disc may be upside down.$ This operation is not available.¾ Some operations are unsupported by the unit. For example;– BD-Video: During playback, reverse slow-motion orreverse frame-by-frame is not possible.IP address is not set.¾ The “IP Address” in “IP Address / DNS Settings” is “---.---. ---. ---”. Set the “IP Address”, “Subnet Mask”, and“Gateway Address”. (Select the automatic addressacquisition if necessary.)The wireless access point currently has a lownetwork security setting. It is recommended tochange to a higher setting.¾ Authentication type for the Wireless LAN is set to “Opensystem”, or the encryption type is set to “No encryption”.It is recommended to encrypt for safety reasons. Fordetails, refer to the instructions of the Wireless routerbeing used. Encryption is required when playing backvideo, etc., from DLNA compatible devices.F99¾ The unit fails to operate properly. Press [Í/I] on themain unit for 3 seconds to switch the unit to standby,then switch back on.HDMI ONLY¾ Some BD-Video discs can only be output with HDMI.NET¾ While connecting to a network.No PLAY¾ There is a viewing restriction on a BD-Video orDVD-Video. ( 31)No READ¾ The media is dirty or badly scratched. The unit cannotplay.PLEASE WAIT¾ The unit is carrying out internal process. This is not amalfunction. You cannot operate the unit while “PLEASEWAIT” is displayed.REMOVE¾ The USB device is drawing too much power. Removethe USB device.SET (“ ” stands for a number.)¾ The remote control and main unit are using differentcodes. Change the code on the remote control.Press and hold [OK] and theindicated number button at thesame time for more than 5 seconds.U59¾ The unit is hot.The unit switches to standby for safety reasons. Wait forabout 30 minutes until the message disappears.Select a position with good ventilation when installing theunit. Do not block the ventilation hole on the side of theunit.H or F(“ ” stands for a number.)¾ There is something unusual.¾ Check the unit using the troubleshooting guide. If theservice number does not disappear, do the following.1 Disconnect the plug from the household mains socketwait a few seconds, then reconnect it.2 Press [Í/I] to turn the unit on. (The unit may be fixed.)If the service number does not disappear despite doing theabove, request service from the dealer. Inform the dealer ofthe service number when requesting service.START¾ The system is being restarted during the firmwareupdate. Please do not turn off the unit.UPD/(“ ” stands for a number.)¾ The firmware is being updated.Please do not turn off the unit.FINISH¾ The firmware update is complete.On the televisionOn the unit’s display